A MEMS Ultra-Wideband (UWB) Power Sensor with a Fe-Co-B Core Planar Inductor and a Vibrating Diaphragm Capacitor

Abstract

The design of a microelectromechanical systems (MEMS) ultra-wideband (UWB) RMS power sensor is presented. The sensor incorporates a microfabricated Fe-Co-B core planar inductor and a microfabricated vibrating diaphragm variable capacitor on adhesively bonded glass wafers in a footprint area of 970 × 970 µm2 to operate in the 3.1–10.6 GHz UWB frequency range. When exposed to a far-field UWB electromagnetic radiation, the planar inductor acts as a loop antenna to generate a frequency-independent voltage across the MEMS capacitor. The voltage generates a coulombic attraction force between the diaphragm and backplate that deforms the diaphragm to change the capacitance. The frequency-independent capacitance change is sensed using a transimpedance amplifier to generate an output voltage. The sensor exhibits a linear capacitance change induced voltage relation and a calculated sensitivity of 4.5 aF/0.8 µA/m. The sensor can be used as a standalone UWB power sensor or as a 2D array for microwave-based biomedical diagnostic imaging applications or for non-contact material characterization. The device can easily be tailored for power sensing in other application areas such as, 5G, WiFi, and Internet-of-Things (IoT). The foreseen fabrication technique can rely on standard readily available microfabrication techniques.

A 146-dB-Ohm Gain 14-pARMS Noise Patch-Clamp Amplifier for Whole-Cell Ion Current Detection

“…Table 3 summarizes the main performance of the proposed PCA compared to the prior art [22,23] and commer-cial devices (Axopatch 200B) [20,24]. The proposed design shows a wider bandwidth and higher capacitance compensation and is the only design that integrates a glass microelectrode series resistance/capacitance compensation circuit and feedback resistor parasitic capacitance compensation.…”

Multiple Quartz Crystals Connected in Parallel for High-Resolution Sensing of Capacitance Changes

“…A variable inductivity, L com , is used to fine-tune both frequencies f 1 and f 2 for reactances −1/jωC l p and −1/jωC lr at a certain frequency f r , and to set the sensitivity of the sensor [28,[44][45][46][47]. A pulse-wide modulated signal corresponding to the frequency difference between the frequency f 1 and reference frequency f r (from reference oscilator) or the difference between the frequency f 2 and reference frequency enters the BPF (Band Pass Filter) [48][49][50]. If the frequencies f 1 and f 2 (in our case) equal approximately 4 MHz and are a few kHz different from the frequency f r , then these two frequencies are converted (depending on the signal S con ) to the range between 4 and 100 kHz at the output of BPF.…”