A low EMI SIDO wireless power transfer system with 10&amp;#x03BC;sec response time

Kawajiri, Toru; Moroto, Takahiro; Ishikuro, Hiroki

doi:10.1109/esscirc.2015.7313875

Cited by 3 publications

(1 citation statement)

References 7 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…For example, for implanted medical devices, different voltages are needed to supply digital and analog modules; due to the special implanted environment, a small chip size is required. Figure 2b presents a single-stage dual-output receiver, which is realized by two self-regulating rectifiers linking with the same secondary coil in parallel [14]. However, cross-regulation occurs due to the shared inductor.…”

Section: Introductionmentioning

confidence: 99%

A 125 KHz, Single-Stage, Dual-Output Wireless Power Receiver with PSM Modulation

et al. 2022

View full text Add to dashboard Cite

This paper presents a 125 KHz, single-stage, dual-output wireless power receiver with pulse skip modulation (PSM). Multi-output receivers are proposed to supply different modules in one system. Conventional multi-output receivers contain a rectifier and a multi-output regulator, which degrade the power conversion efficiency (PCE) due to interstage loss of the rectifier and the regulator. Additionally, existing single-inductor multi-output (SIMO) receivers exhibit a cross-regulation phenomenon because of the sharing inductor, which decreases the stability of the output voltages, and the use of an inductor in SIMO receivers increases the cost of the circuit. The proposed receiver in this article realizes rectification and regulation in only one stage, which eliminates interstage loss; this improves the power conversion efficiency of the system and realizes dual-output voltages with only four power transistors without an inductor, which reduces the chip area and minimizes cost. There is no cross-regulation in this dual-output architecture because the dual-output voltages are charged by different phases of the input signal. PSM modulation was adopted to regulate output voltages for higher efficiency. The proposed single-stage, dual-output regulating rectifier delivers a maximum power of 47 mW, and the dual-output voltages are 1.8 V and 2 V. This receiver is designed by a 0.18 μm complementary metal-oxide-semiconductor (CMOS) process and realizes a peak efficiency of 86% when the output power ranges from 15 mW to 47 mW.

show abstract

Section: Introductionmentioning

confidence: 99%