“…Therefore, previous studies have attempted to find a solution, hoping to solve the problems of air pollution, global warming, and energy shortage by using highly efficient renewable energy systems. The current more mature and widely used renewable energy sources include solar, wind, and tidal energy sources [2][3][4]. Often these renewable energy sources have low-voltage output and must pass through a set of high boost converter circuits to increase the voltage, and then through a DC-AC inverter to convert AC voltage from the main supply in parallel.…”
Abstract:In this study, a novel high step-up DC-DC converter was successfully integrated using coupled inductor and switched capacitor techniques. High step-up DC-DC gain was achieved using a coupled inductor when capacitors charged and discharged energy, respectively. In addition, energy was recovered from the leakage inductance of the coupled inductor by using a passive clamp circuit. Therefore, the voltage stress of the main power switch was almost reduced to 1/7 V o (output voltage). Moreover, the coupled inductor alleviated the reverse-recovery problem of the diode. The proposed circuit efficiency can be further improved and high voltage gain can be achieved. The operation principle and steady-state analysis of the proposed converter were discussed. Finally, a hardware prototype circuit with input voltage of 24 V, output voltage of up to 400 V, and maximum power of 150 W was constructed in a laboratory; the maximum efficiency was almost 96.2%.
“…Therefore, previous studies have attempted to find a solution, hoping to solve the problems of air pollution, global warming, and energy shortage by using highly efficient renewable energy systems. The current more mature and widely used renewable energy sources include solar, wind, and tidal energy sources [2][3][4]. Often these renewable energy sources have low-voltage output and must pass through a set of high boost converter circuits to increase the voltage, and then through a DC-AC inverter to convert AC voltage from the main supply in parallel.…”
Abstract:In this study, a novel high step-up DC-DC converter was successfully integrated using coupled inductor and switched capacitor techniques. High step-up DC-DC gain was achieved using a coupled inductor when capacitors charged and discharged energy, respectively. In addition, energy was recovered from the leakage inductance of the coupled inductor by using a passive clamp circuit. Therefore, the voltage stress of the main power switch was almost reduced to 1/7 V o (output voltage). Moreover, the coupled inductor alleviated the reverse-recovery problem of the diode. The proposed circuit efficiency can be further improved and high voltage gain can be achieved. The operation principle and steady-state analysis of the proposed converter were discussed. Finally, a hardware prototype circuit with input voltage of 24 V, output voltage of up to 400 V, and maximum power of 150 W was constructed in a laboratory; the maximum efficiency was almost 96.2%.
This article reviews the renewable energy systems emulators proposals for microgrid laboratory testing platforms. Four emulation conceptual levels are identified based on the literature analysis performed. Each of these levels is explained through a microgrid example, detailing its features and possibilities. Finally, an experimental microgrid, built based on emulators, is presented to exemplify the system performance.
“…Son yıllarda, fosil enerji gibi klasik enerji kaynaklarının miktarının azaldığı ve yakın gelecekte biteceği bilimsel çevreler tarafından söylenmektedir [1]. Yenilenebilir enerji kaynakları, sanayileşmeye bağlı olarak oluşan yüksek enerji ihtiyacı ve fosil yakıtlarının miktarının azalması ile birlikte dikkat çeken bir konu haline gelmiştir [2].…”
Section: Gi̇ri̇ş (Introduction)unclassified
“…Yenilenebilir enerji kaynakları, sanayileşmeye bağlı olarak oluşan yüksek enerji ihtiyacı ve fosil yakıtlarının miktarının azalması ile birlikte dikkat çeken bir konu haline gelmiştir [2]. Tüm yenilenebilir enerji kaynakları içerisinde; sessiz, temiz ve güneş var olduğu sürece kullanılabilecek tükenmez bir kaynak olduğu için fotovoltaik enerji son zamanlarda ilgi çekici bir konu haline gelmiştir [1]. Ek olarak kurulum maliyetinin düşük olması ve işletme maliyetinin de oldukça düşük olması sebebiyle FV sistemlerine olan ilgi gün geçtikçe artmaktadır [3].…”
Section: Gi̇ri̇ş (Introduction)unclassified
“…Güneş hücresi veya dizisi kullanan fotovoltaik sistemlerin çıkış karakteristikleri (I-V karakteristiği) hava koşullarına bağlıdır [1,4]. Hava koşulları her an değişken ve kontrol edilemez olduğundan araştırmacılar, önerdikleri maksimum güç izleme algoritmalarının kalitesini doğrulamak için kullandıkları gerçek FV panel ile her zaman aynı I-V karakteristiği bulamayabilirler [5].…”
ÖZGüneş hücresi veya dizisi kullanan Fotovoltaik (FV) sistemlerin akım (I) -gerilim (V) ve güç (P) -gerilim (V) karakteristikleri hava koşullarına bağlıdır. Araştırmacıların, tekrarlanabilen laboratuvar koşullarında maksimum güç izleyici veya izleyici algoritmalarının performanslarını tespit edebilmeleri amacıyla güneş hücresi veya dizisinin (FV panel) çıkış karakteristiğine benzeyen ve gerçekçi verileri verebilen yardımcı bir ekipmana ihtiyaçları vardır. Bu ekipmana literatürde FV simülatör adı verilmektedir. Bu çalışmada, FV panellerin laboratuvar ortamında modellenmesi için geliştirilen yeni bir FV simülatör yapısı önerilmiştir. Önerilen FV simülatör seri bağlı kaskat modüllerden meydana gelmektedir. FV simülatörün en belirgin özelliği modül sayısının kolaylıkla arttırılabilmesidir. Böylece FV simülatörün çıkış geriliminin seviye sayısı artmaktadır. Bu özellik sayesinde FV simülatörün I-V eğrisi, modellenmek istenen gerçek FV panelin I-V eğrisine daha çok benzemektedir. Önerilen yapının performansını göstermek amacıyla bir simülasyon çalışması yapılmıştır. Simülasyon çalışmasında, ilk önce gerçek bir FV panelin I-V verileri simülasyon programına yüklenmiştir. Gerçek I-V verileri kullanılarak FV simülatör için gerekli anahtarlama sinyalleri simülasyon programında oluşturulmuştur. 5 ve 6 modüllü durum için FV simülatörün I-V ve P-V eğrileri elde edilmiş ve gerçek FV panelin eğrileri ile karşılaştırılmıştır. Ayrıca farklı güneş ışınımları ve parçalı gölgelenme durumları için de I-V ve P-V eğrileri elde edilmiş ve sonuçları verilmiştir. Modül sayısı arttıkça gerçek FV panel ile önerilen FV simülatörün I-V ve P-V eğrileri birbirine çok yakın çıkmaktadır. Önerilen yapının FV simülatör olarak kullanılması oldukça uygundur. Gerek modüler yapıya sahip olması gerekse elde edilen sonuçlar dikkate alındığında, önerilen simülatörün yüksek gerilim ve güç uygulamalarında kullanılmaya elverişli olduğu görülmektedir.Anahtar Kelimeler: FV simülatör, fotovoltaik simülatör, I-V eğrisi, P-V eğrisi, parçalı gölgelenme Development of a new PV simulator structure for modelling PV arrays ABSTRACT Current (I) -voltage (V) and power (P) -voltage (V) characteristics of Photovoltaic (PV) systems using solar cell or array depend on weather conditions. In order to test MPP trackers or MPPT algorithms in repeatable laboratory conditions, researchers need equipment that gives a realistic data similar to output
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.