A flexible self-poled piezocomposite nanogenerator based on H2(Zr0.1Ti0.9)3O7 nanowires and polylactic acid biopolymer

Hanani, Zouhair; Izanzar, Ilyasse; Merselmiz, Soukaina; Assimi, Taha El; Mezzane, D.; Amjoud, M.; Ghanbaja, Jaâfar; Saadoune, Ismae͏̈l; Lachini, Mohammed; Spreitzer, Matjaž; Vengust, Damjan; Marssi, M. El; Kutnjak, Zdravko; Luk’yanchuk, I.; Gouné, Mohamed

doi:10.1039/d2se00234e

Cited by 13 publications

(11 citation statements)

References 79 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Very recently, Hanani et al introduced a novel inorganic ferroelectric–polymer composite composed of H 2 (Zr 0.1 Ti 0.9 ) 3 O 7 nanowires (HZTO-NW) and polylactic acid (PLA) biopolymer (HZTO-nw@PDA/PLA). 66 The d 33 value of HZTO-NW was found to be 26 pm V −1 . A solution casting technique was used to prepare an HZTO-NW@PDA/PLA composite film.…”

Section: Flexible Ferroelectric Materials and Recent Developmentsmentioning

confidence: 98%

Inorganic ferroelectric thin films and their composites for flexible electronic and energy device applications: current progress and perspectives

et al. 2023

View full text Add to dashboard Cite

show abstract

Section: Flexible Ferroelectric Materials and Recent Developmentsmentioning

confidence: 98%

Inorganic ferroelectric thin films and their composites for flexible electronic and energy device applications: current progress and perspectives

et al. 2023

View full text Add to dashboard Cite

show abstract

“…The local polarization state and dynamic domain switching behavior of the PNCU 1 were investigated using PFM measurements. Because of the direct tip-surface interaction, PFM has high spatial resolution and sensitivity to local polarization, ,, making it an ideal tool for studying the ferroelectric domain at the nanoscale. The amplitude picture of PFM reveals a nearly regular spontaneous domain (Figure S5a,b).…”

Section: Resultsmentioning

confidence: 99%

Self-Charging Piezo-Supercapacitor: One-Step Mechanical Energy Conversion and Storage

Mondal

Thakur

Maiti³

et al. 2023

ACS Appl. Mater. Interfaces

View full text Add to dashboard Cite

With the contemplations of ecological and environmental issues related to energy harvesting, piezoelectric nanogenerators (PNGs) may be an accessible, sustainable, and abundant elective wellspring of energy in the future. The PNGs’ power output, however, is dependent on the mechanical energy input, which will be intermittent if the mechanical energy is not continuous. This is a fatal flaw for electronics that need continuous power. Here, a self-charging flexible supercapacitor (PSCFS) is successfully realized that can harvest sporadic mechanical energy, convert it to electrical energy, and simultaneously store power. Initially, chemically processed multimetallic oxide, namely, copper cobalt nickel oxide (CuCoNiO4) is amalgamated within the poly(vinylidene fluoride) (PVDF) framework in different wt % to realize high-performance PNGs. The combination of CuCoNiO4 as filler creates a notable electroactive phase inside the PVDF matrix, and the composite realized by combining 1 wt % CuCoNiO4 with PVDF, coined as PNCU 1, exhibits the highest electroactive phase (>86%). Under periodic hammering (∼100 kPa), PNGs fabricated with this optimized composite film deliver an instantaneous voltage of ∼67.9 V and a current of ∼4.15 μA. Furthermore, PNG 1 is ingeniously integrated into a supercapacitor to construct PSCFS, using PNCU 1 as a separator and CuCoNiO4 nanowires on carbon cloth (CC) as the positive and negative electrodes. The self-charging behavior of the rectifier-free storage device was established under bending deformation. The PSCFS device exhibits ∼845 mV from its initial open-circuit potential ∼35 mV in ∼220 s under periodic bending of 180° at a frequency of 1 Hz. The PSCFS can power up various portable electronic appliances such as calculators, watches, and LEDs. This work offers a high-performance, self-powered device that can be used to replace bulky batteries in everyday electronic devices by harnessing mechanical energy, converting mechanical energy from its environment into electrical energy.

show abstract

“…The detailed structural, morphological and piezoelectric characterisation can be found in the literature. 30,36…”

Section: Methodsmentioning

confidence: 99%

“…Previously, we reported the piezoelectric energy harvesting of lead-free H 2 (Zr 0.1 Ti 0.9 ) 3 O 7 nanowires embedded in a PLA matrix and observed enhanced output performances (open-circuit voltage of 5.41 V and short-circuit current of 0.26 μA) and could drive small commercial electronics under various human motions). 30…”

Section: Introductionmentioning

confidence: 99%

The benefits of combining 1D and 3D nanofillers in a piezocomposite nanogenerator for biomechanical energy harvesting

et al. 2022

Self Cite

View full text Add to dashboard Cite

show abstract

A flexible self-poled piezocomposite nanogenerator based on H₂(Zr_0.1Ti_0.9)₃O₇ nanowires and polylactic acid biopolymer

Abstract: The field of Piezoelectric nanogenerators is rapidly growing as promising technology for driving low-power portable devices and self-powered electronic systems by converting wasted mechanical energy into electric energy. In this...

Cited by 13 publications

References 79 publications

Inorganic ferroelectric thin films and their composites for flexible electronic and energy device applications: current progress and perspectives

Inorganic ferroelectric thin films and their composites for flexible electronic and energy device applications: current progress and perspectives

Self-Charging Piezo-Supercapacitor: One-Step Mechanical Energy Conversion and Storage

The benefits of combining 1D and 3D nanofillers in a piezocomposite nanogenerator for biomechanical energy harvesting

Contact Info

Product

Resources

About