A Feasibility Investigation on Improving Structural Integrity of Thermoelectric Modules With Varying Geometry

Abstract

This study investigates the feasibility of improving the structural integrity of thermoelectric modules (TEMs) with varying geometry. For this purpose, six different TEM models with various thermoelectric leg geometries were designed and modeled in order to perform a thermal stress FEA using ANSYS Workbench. Temperature dependent material properties were used since some properties such as coefficients of thermal expansion change with temperature. Significant decrease in thermal stresses and leg deformations were observed with some models. Particularly, the cylindrical TE leg geometry model has approximately 54% lower Von Mises stresses (294MPa) and 13% lower TE leg deformations (3.9μm) than those of the typical TE leg geometry model (635MPa and 4.5μm). Power generation analyses of the models were performed to evaluate the effect of new TE leg geometries on the performance. TEM model with cylindrical TE leg geometry has the highest power generation (29.3mW) among all the models.

Artificial Neural Network and Adaptive Neuro-Fuzzy Interface System Modelling to Predict Thermal Performances of Thermoelectric Generator for Waste Heat Recovery

“…The thermal efficiency of the thermoelectric generator system for waste heat recovery could be calculated with Equation (11) as the ratio of the power generated by the thermoelectric modules (P) to the heat transfer through the thermoelectric modules ( . Q) [36]:…”

Studying the influence of the thermoelectric materials parameters on the dynamics of single­cascade cooling devices

“…The study was conducted only for the static modes of operation and the requirements for stricter operating conditions for on-board systems required further research to improve reliability indicators [5]. One of the most important structural parameters that affect the reliability indicators of thermoelectric coolers is the variation of geometric parameters and the structural integrity of thermoelectric modules, which was addressed in [6]. The dynamic indicators were not considered because thermoelectric coolers have a significant advantage compared to air and liquid cooling systems.…”

Developing a model to control the thermal mode of thermoelectric cooling devices by minimizing the set of three basic parameters

“…Further research was aimed at taking into consideration stricter operating conditions and improving the reliability indicators of thermoelectric coolers at all stages of their life cycle [6]. Taking into consideration the impact of the design parameters of thermoelectric coolers and the structural integrity of their modules on reliability indicators has made it possible to optimize the performance of the device under a static mode [7]. Subsequent studies were aimed at analyzing the dynamic characteristics of thermoelectric coolers as the increase in the temperature gradient in the soldered joint between the thermoelement and electrode leads to an increase in temperature stresses and a decrease in reliability [8].…”