A comparison of quality management for bored pile/drilled shaft (BP/DS) foundation construction and the implementation of recent technologies

Hertlein, Bernard; Verbeek, Gerald; Fassett, Robert G.; Arnold, Michael

doi:10.1080/19375247.2016.1255426

Cited by 7 publications

(1 citation statement)

References 0 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Design and construction processes involve tools and techniques for ensuring the quality of materials and workmanship during the construction process, thus providing QA. The techniques used in QM include visual inspection from the top of the excavation, downhole camera, shaft inspection device, and base grouting [4]. QC is defined as the verification of foundation integrity and capacity, and it utilises technologies for flaws location in material and load tests [5].…”

Section: Introductionmentioning

confidence: 99%

Assessment of surface parameters of VDW foundation piles using geodetic measurement techniques

Muszyński

Wyjadłowski

2020

Open Geosciences

View full text Add to dashboard Cite

This article presents in situ research on the side surface of Vor der Wand (VDW) foundation piles using 3D laser scanning and close-range photogrammetry to assess the morphology of pile concrete surface. Contemporary analytical methods for estimation of the bearing capacity of the foundation pile surface require determination of the parameters of the concrete roughness and the model of the surface being formed, which corresponds to the pile technology used. Acquiring these data is difficult due to the formation of piles in the ground and their subsequent work as a structure buried in the ground. The VDW pile technology is one of the widespread technologies of foundation pile used in practice. These piles exhibit a specific configuration of the lateral surface, which is related to the simultaneous use of auger drilling and casing that rotates in opposite directions. Two geodetic techniques most often used to measure the geometry of buildings are terrestrial laser scanning and close-range photogrammetry. To empirically verify the suitability of these two techniques for describing the VDW pile surface parameters, a two-stage field study was performed. In the first stage, the measurements of concrete test surfaces were conducted. This surface was formed in a smooth formwork and its roughness parameters (in accordance with ISO 25178-2: 2012) were calculated and compared with the reference surface. In the second stage, measurements of the secant VDW sheet pile wall protecting the deep excavation were carried out. The roughness parameters of the pile surface were calculated for the selected areas in diverse geotechnical conditions. The original procedure for processing data (obtained using the above techniques) for assessment of roughness parameters of unique concrete surfaces was presented. The conducted research demonstrates that a pulse scanner has very limited usefulness for determination of roughness parameters for very smooth concrete surface; however, the photogrammetry techniques give acceptable results. In regard to the VDW pile surface, the results obtained from both measurement techniques give satisfactory consistency of the roughness parameters. The relative errors of calculated roughness parameters do not exceed 29% (average 12%). The proposed procedure may improve the accuracy of the assumed friction factor between pile surface and soil for assessment of the pile shaft bearing capacity for various pile technologies and soil conditions.

show abstract

Section: Introductionmentioning

confidence: 99%