A Comparative Study on the Texture of Exposed Aggregate Concrete (EAC) Pavements Using Different Measurement Techniques

Abstract

This paper presents issues related to the assessment of the texture of aggregate concrete (EAC) surfaces using various methods for its verification. Microtexture was assessed using the British Pendulum Tester (BPT) and Dynamic Friction Tester (DFT). Two laser profilometers were used to assess macrotexture, circular texture meter (CTM) and stationary laser profilograph (SPL), as well as the commonly known volumetric method. Measurements were carried out on left and right tracks and in between them on five test sections of expressways. Based on the analyses performed, it was found that the results obtained by the DFT were less sensitive to changes in microtexture between individual tracks compared to the results obtained by the BPT. The BPN values in the left track were lower than those in the right track. However, the difference between the DFT20 results in these spots was insignificant. Both MPD and MTD values did not show significant differences between the right and left tracks. However, some differences were observed between the MPD parameters obtained using the CTM and SPL. This resulted from the different frequency and length of the scanned surface profile. However, the differences were at an acceptable level. A very high linear correlation was obtained in the case of BPN and DFT20 values (r − 0.719), and in the case of MPD and MTD values, the correlation was almost certain (r above 0.900). Based on a comparative analysis of the models estimating mean texture depth (MTD/ETD), a significant difference was observed between models based on EAC pavement results and those based on asphalt surfaces.