A comparative study of erosion wear rate of conventional and nonconventional thermal barrier coatings on IN800 superalloys

Kumar, Dhirendra; Npandey, K

doi:10.1007/s12046-021-01653-w

Cited by 7 publications

(1 citation statement)

References 53 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Ma Y P et al [ 18 ] conducted erosion wear tests on magnesium alloys before and after surface diffusion alloying treatment and demonstrated the effective resistance to erosion wear after surface diffusion alloying treatment. Kumar et al [ 19 ] studied the materials and processes of 7YSZ coatings regarding erosion wear at room temperature and at high temperatures of 850 °C. Most of these studies focused on the influence of material aspects of the target object on erosion wear, but the influence of other factors on erosion wear is rarely considered and comparatively analyzed.…”

Section: Introductionmentioning

confidence: 99%

CFD-Based Physical Failure Modeling of Direct-Drive Electro-Hydraulic Servo Valve Spool and Sleeve

Guo-qin

Yang

et al. 2022

Sensors

View full text Add to dashboard Cite

Direct-drive electro-hydraulic servo valves are used extensively in aerospace, military and control applications, but little research has been conducted on their service life and physical failure wear. Based on computational fluid dynamics, the main failure forms of direct-drive electro-hydraulic servo valves are explored using their continuous phase flow and discrete phase motion characteristics, and then combined with the theory of erosion for calculation. A mathematical model of the direct-drive electro-hydraulic servo valve is established by using Solidworks software, and then imported into Fluent simulation software to establish its physical failure model and carry out simulation. Finally, the physical failure form of the direct drive electro-hydraulic servo valve is verified by the simulation results, and the performance degradation law is summarized. The results show that temperature, differential pressure, solid particle diameter and concentration, and opening degree all have an impact on the erosion and wear of direct-drive electro-hydraulic servo valves, in which differential pressure and solid particle diameter have a relatively large impact, and the servo valve must avoid working in the range of high differential pressure and solid particle diameter of 20–40 um as far as possible. This also provides further theoretical support and experimental guidance for the industrial application and life prediction of electro-hydraulic servo valves.

show abstract

Section: Introductionmentioning

confidence: 99%