A 22-mW 435 MHz silicon on insulator CMOS high-gain LNA for subsampling receivers

Huang, Tom; Zencir, Ertan; Yuce, Mehmet Rasit; Dogan, N.S.; Liu, W.; Arvas, E.

doi:10.1109/iscas.2003.1205589

Cited by 5 publications

(2 citation statements)

References 7 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…(4) where Da t a I N (n) is the nth complex sample of the input data and Da t a O U T (n) is the nth complex sample of the output of the I and Q IF bandpass filters of the terminal receiver. A SNR of at least 15dB is required for an acceptable bit error rate.…”

Section: Simulation Resultsmentioning

confidence: 99%

See 1 more Smart Citation

SOC design of an IF subsampling terminal for a gigabit wireless LAN with asymmetric equalization

Pekau¹,

Nakaska²,

Kulyk³

et al.

4th IEEE International Workshop on System-on-Chip for Real-Time Applications

View full text Add to dashboard Cite

The design of a simple IF subsampling terminal for a gigabit wireless local area network is presented. All equalization is performed in the base station, allowing the terminal to be implemented using simplified hardware without any digital signal processing. System design of the WLAN terminal is discussed and simulation results are presented for an SOC implementation of the terminal receiver with realistic block specifications. The WLAN uses 16-QAM modulation with a data rate of 1.6Gbit/s, and has a 400MHz signal bandwidth modulated on a 10.4GHz carrier, downconverted to an intermediate frequency of 800MHz.

show abstract

Section: Simulation Resultsmentioning

confidence: 99%

“…In an IF sampling receiver, gain is realized by the LNA and, depending on the specific architecture, by the mixer and the IF amplifier. LNA's for IF sampling receivers have been designed with 80dB of gain [4], but at 10.4GHz very high gain S11 S21…”

Section: Low Noise Amplifiermentioning

confidence: 99%