Untitled

Wang, W.; Guo, Hongliang; Gao, Jianping; Dong, Xu; Qin, Qiaoyun

doi:10.1023/a:1004741215543

Cited by 43 publications

(16 citation statements)

References 2 publications

Supporting

Mentioning

Contrasting

Unclassified

Order By: Relevance

“…4c). These results are consistent with experimental results, as PPSA (a copolymer formed by combination of PPS and PANI) is less conductive than the homopolymers PPS and PANI 12 . For the A 1 D 45 F 54 copolymer the found solution satisfies the conditions for metallic regime.…”

Section: Quintenary Alloysupporting

confidence: 92%

Using artificial intelligence methods to design new conducting polymers

2003

View full text Add to dashboard Cite

In the last years the possibility of creating new conducting polymers exploring the concept of copolymerization (different structural monomeric units) has attracted much attention from experimental and theoretical points of view. Due to the rich carbon reactivity an almost infinite number of new structures is possible and the procedure of trial and error has been the rule. In this work we have used a methodology able of generating new structures with pre-specified properties. It combines the use of negative factor counting (NFC) technique with artificial intelligence methods (genetic algorithms -GAs). We present the results for a case study for poly(phenylenesulfide phenyleneamine) (PPSA), a copolymer formed by combination of homopolymers: polyaniline (PANI) and polyphenylenesulfide (PPS). The methodology was successfully applied to the problem of obtaining binary up to quinternary disordered polymeric alloys with a pre-specific gap value or exhibiting metallic properties. It is completely general and can be in principle adapted to the design of new classes of materials with pre-specified properties.

show abstract

Section: Quintenary Alloysupporting

confidence: 92%

Using artificial intelligence methods to design new conducting polymers

2003

View full text Add to dashboard Cite

show abstract

“…In Fig. 8b, the peaks at lower binding energy (180.4, 182.4, 182.8 eV) can be attributed to Zr 3d 5/2 which may correspond to ZrO [42,43]. The peak at the binding energy of 183.3 eV can be assigned to Zr 3d 5/2 and the other two peaks at the higher binding energies of 184.8 and 185.3 eV are attributed to Zr 3d 3/2 and all these three peaks correspond to Zr 4+ in ZrO 2 [44].…”

Section: The Xps Studymentioning

confidence: 96%

The performance improvement of Zr conversion coating through Mn incorporation: With and without organic coating

Hosseini

Sarabi

Mohammadloo

et al. 2014

Surface and Coatings Technology

View full text Add to dashboard Cite

“…However, we should mention a study of microsized Ni-ZrO 2 composites prepared by composite electrodeposition, where the Ni/ZrO 2 interface interactions were investigated by different techniques with atomic resolution, including several spectroscopies (XPS, UPS and electron spin resonance) [241]. TEM and X-ray measurements indicate that no new phases are formed in the interfacial region.…”

Section: Nanocompositesmentioning

confidence: 99%