3D Printing Technology for Rapid Manufacturing Discone Antenna Based on PLA Material

Munir, Achmad; Zulfi,; Asthan, Rheyuniarto Sahlendar; Oktafiani, Folin

doi:10.1109/cicn56167.2022.10008352

Cited by 7 publications

(1 citation statement)

References 15 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…This allows 3D shapes as well. The literature mentions results on printed antennas in 3D polymer structures [5,[40][41][42][43][44][45][46], but to the best of our knowledge, only one author [8] mentioned the fabrication of rectifier on polymer substrate using resin, and none on PLA. PLA as the chosen polymer for substrate has been primarily identified in terms of RF properties to support design of a rectenna.…”

Section: Discussionmentioning

confidence: 99%

Evaluation of Polylactic Acid Polymer as a Substrate in Rectenna for Ambient Radiofrequency Energy Harvesting

Linge

Gerges

Bevilacqua

et al. 2023

JLPEA

View full text Add to dashboard Cite

This work details the design and experimental characterization of a 2D rectenna for scavenging radio frequency energy at 2.45 GHz (WiFi band), fabricated on polylactic acid polymer (PLA) using a plastronics approach. PLA is the RF substrate of both antenna and rectifier. The two transmission line (TTL) approach is used to characterize the substrate properties to be considered during design. A linearly polarized patch antenna with microstrip transmission feeding is connected to a single series diode rectifier through a T-matching network. The antenna has simulated and measured gain of 7.6 dB and 7.5 dB, respectively. The rectifier has a measured DC output power of 0.96 μW at an optimal load of 2 kΩ under RF input power of −20 dBm at 2.45 GHz. The power conversion efficiency is 9.6% in the latter conditions for a 54 × 36 mm patch antenna of a 1.5 mm thick PLA substrate obtained from additive manufacturing. The power conversion efficiency reaches a value of 28.75% when the input power is −10 dBm at 2.45 GHz. This corresponds to a peak DC power of 28.75 μW when the optimal load is 1.5 kΩ. The results compare significantly with the ones of a similar rectenna circuit manufactured on preferred RF substrate.

show abstract