2D Finite Element Modeling of the Cutting Force in Peripheral Milling of Cellular Metals

Abstract

The machining of cellular metals has been a challenge, as the resulting surface is extremely irregular, with torn off or smeared material, poor accuracy, and subsurface damage. Although cutting experiments have been carried out on cellular materials to study the influence of cutting parameters, current analytical and experimental techniques are not suitable for the analysis of heterogeneous materials. On the other hand, the finite element (FE) method has been proven a useful resource in the analysis of heterogeneous materials, such as cellular materials, metal foams, and composites. In this study, a two-dimensional finite element model of peripheral milling for cellular metals is presented. The model considers the kinematics of peripheral milling, depicting the advance of the tool into the workpiece and the interaction between the cutting edge and the mesostructure. The model is able to simulate chip separation as well as the surface and subsurface damage on the machined surface. Although the calculated average cutting force is not accurate, the model provides a reasonable estimation of maximum cutting force. The influences of mesostructure on cutting processes are highlighted and the effects in peripheral milling of cellular materials are discussed.

On the Role of Hollow Aluminium Oxide Microballoons during Machining of AZ31 Magnesium Syntactic Foam

“…It has been shown by several studies that the machining of porous materials has been a challenging task primarily due to severe subsurface damage and smeared material caused as a result of chip tearing and heterogenous crack propagation during chip formation. Rafael et al [22] have studied the interaction between the tool edge and the mesostructure during the peripheral milling of heat resistant austenitic stainless-steel cellular material. The chip formation and cutting forces were found to be highly dependent on the arrangement of cells.…”

A Study for Improved Prediction of the Cutting Force and Chip Shrinkage Coefficient during the SKD11 Alloy Steel Milling

“…Converting 3D FEM-based to orthogonal 2D FEM-based simulations effectively reduced the number of elements and improved the simulation time. Although orthogonal 2D FEM-based simulations do not fully reproduce the geometric complexity and features of the full 3D milling process, they are very helpful for providing detailed information about the machining process [6].…”

Special Issue ‘Advanced and High Performance Metallic Foams’

“…Last but not least, a study on the machinability of foams was published by Silva et al [ 12 ]. The machining of cellular metals has been a challenge, as the resulting surface is extremely irregular, with torn off or smeared material and poor accuracy.…”