Experiments of a 100 kV-level pulse generator based on metal-oxide varistor

In recent years, the pulse forming technology based on metal oxide varistors (MOVs) has been verified to be an effective way to generate high-voltage quasi-square pulses. Due to the limited varistor voltage of a single MOV brick, multiple MOV bricks connected in series are required to stabilize a pulse with high amplitude (larger than hundreds of kV), which leads to the rise of the series inductance of the MOV branch and the flat-top droop in the output waveform. This paper provides two solutions to reduce the influence of the MOV branch inductance on output waveforms. One is that a coaxial evolute structure of the MOV bricks connected in series is designed, which can not only improve the insulation capacity but also reduce the branch inductance. Another is that a flat-top compensation scheme named “PFN-MOV” (Pulse Forming Network) is proposed, which adds an LC filtering branch to shape the signal into a flat-top rising wave with ripple and then offsets the flat-top droop caused by the inductance of the MOV branch. Based on the above ideas, a high-voltage, long-pulse width, flat-top compensation pulse generator is designed and tested, and a quasi-square pulse with voltage amplitude of more than 500 kV, pulse width greater than 800 ns, rise time of less than 50 ns, and flat top of about 600 ns is obtained experimentally. This MOV based generator has the advantage of simple design, compact construction, and better flat top, which is promising to be used as a compact long-pulse driver in many fields, such as high-current accelerator, industrial dedusting, medical sterilization, and cancer treatment.

The design of a high-voltage, long-pulse width, flat-top compensation pulse generator based on metal oxide varistors

Zhang

Yang

et al. 2022

Test of a multi-gigawatt, 800 ns high power microwave driver based on Marx generator and metal-oxide varistors

Yang

Gao

Zhang

et al. 2022

High power microwave (HPM) sources usually require a well-defined rectangular pulse waveform, which is especially true for the case of long pulse (>100 ns), stable, and high efficiency operation. Most long pulse HPM drivers are realized with pulse forming networks. This paper presents a long pulse driver composed of a conventional Marx generator and metal-oxide varistors (MOVs), utilizing the MOV’s nonlinear V–I characteristic. This method is easy to implement, and it has an additional benefit that the voltage can be stabilized even if the load’s impedance changes slightly. A low inductance zig-zag folding structure of the MOV is designed to decrease its size and self-inductance. An LC filter is used to reduce the energy loss in the MOV. In the experiment, a 400 kV, 800 ns long pulse is achieved at a foil-less electron diode, and longer than 300 ns HPM generation is obtained.

The design of a linear voltage divider based on metal oxide arresters

Xiao,

Shi,

Cheng

et al. 2024

In recent years, linearization technology for nonlinear devices has become a hot topic in many fields. In this study, a linear voltage divider based on metal oxide arresters was designed by combining linearization technology and electrical measurement technology to solve the objective problems of online voltage monitoring. These problems include high difficulty in equipment installation, low measurement accuracy, and poor economic benefits. Based on a summary of linearization theory, the sufficient and necessary conditions for the linearization of the voltage divider were deduced in detail. The relevant circuit simulations were conducted, along with voltage divider experiments under power frequency AC voltage, operating overvoltage, and lightning overvoltage. The results revealed that the voltage divider was able to realize linearized measurements and meet the relevant standards of online voltage monitoring. The measurement errors were concentrated in the transition region between the pre-breakdown region (small current region) and the breakdown region (nonlinear region) in the volt–ampere characteristic curve. The main influencing factor of errors was the consistency of the nonlinear characteristics of the high- and low-voltage arms of the voltage divider. The voltage divider designed in this study can be applied in many scenarios, such as power plants, substations, high-voltage electrical equipment manufacturing plants, and high-voltage laboratories.