Despite being only one-atom thick, defect-free graphene is considered to be completely impermeable to all gases and liquids [1][2][3][4][5][6][7][8][9][10] . This conclusion is based on theory 3-8 and supported by experiments 1,9,10 that could not detect gas permeation through micrometre-size membranes within a detection limit of 10 5 to 10 6 atoms per second. Here, using small monocrystalline containers tightly sealed with graphene, we show that defect-free graphene is impermeable with an accuracy of eight to nine orders of magnitude higher than in the previous experiments. We could discern permeation of just a few helium atoms per hour, and this detection limit is also valid for all other tested gases (neon, nitrogen, oxygen, argon, krypton and xenon), except for hydrogen. Hydrogen shows noticeable permeation, even though its molecule is larger than helium and should experience a higher energy barrier. The puzzling observation is attributed to a two-stage process that involves dissociation of molecular hydrogen at catalytically active graphene ripples, followed by adsorbed atoms flipping to the other side of the graphene sheet with a relatively low activation energy of about 1.0 electronvolt, a value close to that previously reported for proton transport 11,12 . Our work provides a key reference for the impermeability of two-dimensional materials and is important from a fundamental perspective and for their potential applications.From a theory standpoint, monolayer graphene imposes a very high energy barrier for penetration of atoms and molecules. Density-functional-theory calculations predict that the barrier E is at least several eV 2-6 , which should prohibit any gas permeation under ambient conditions. Indeed, one can estimate that at room temperature T it would take longer than the lifetime of the universe to find an atom energetic enough to pierce a defect-free membrane of any realistic size. These expectations agree with experiments that reported no detectable gas permeation through mechanically-exfoliated graphene. The highest sensitivity was achieved using micrometersize wells etched in oxidized silicon wafers, which were sealed with graphene 1,9,10 . In those measurements, a pressurized gas (e.g., helium) could permeate along the SiO 2 layer and gradually fill the microcontainers making so-called 'nanoballoons'. Their consecutive deflation in air could be monitored using atomic force microscopy (AFM), and it was shown that the leakage occurred only along the SiO 2 surface, within several minutes but independently of the number of graphene layers used for the sealing 1 . These studies allowed a conclusion that graphene membranes were impermeable to all gases, at least with the achieved accuracy of 10 5 -10 6 atoms s -1 . This was further corroborated by creating individual atomic-scale defects in graphene nanoballoons, which resulted in their relatively fast deflation/inflation and confirmed the high sensitivity of the method 9,10 .

Large optical anisotropy observed in a broad spectral range is of paramount importance for efficient light manipulation in countless devices. Although a giant anisotropy has been recently observed in the mid-infrared wavelength range, for visible and near-infrared spectral intervals, the problem remains acute with the highest reported birefringence values of 0.8 in BaTiS3 and h-BN crystals. This issue inspired an intensive search for giant optical anisotropy among natural and artificial materials. Here, we demonstrate that layered transition metal dichalcogenides (TMDCs) provide an answer to this quest owing to their fundamental differences between intralayer strong covalent bonding and weak interlayer van der Waals interaction. To do this, we made correlative far- and near-field characterizations validated by first-principle calculations that reveal a huge birefringence of 1.5 in the infrared and 3 in the visible light for MoS2. Our findings demonstrate that this remarkable anisotropy allows for tackling the diffraction limit enabling an avenue for on-chip next-generation photonics.

We report a comprehensive experimental study of optical and electrical properties of thin polycrystalline gold films in a wide range of film thicknesses (from 20 to 200 nm). Our experimental results are supported by theoretical calculations based on the measured morphology of the fabricated gold films. We demonstrate that the dielectric function of the metal is determined by its structural morphology. Although the fabrication process can be absolutely the same for different films, the dielectric function can strongly depend on the film thickness. Our studies show that the imaginary part of the dielectric function of gold, which is responsible for optical losses, rapidly increases as the film thickness decreases for thicknesses below 80 nm. At the same time, we do not observe a noticeable dependence of optical constants on the film thickness for thicker samples. These findings establish design rules for thin-film plasmonic and nanophotonic devices.