This work evaluates the shear strength of pyramidal fin arrays made from various feedstock materials (cylindrical aluminum, spherical nickel, and cylindrical stainless steel 304 powders) deposited on an Al6061-T6 substrate. Higher shear strength was measured for the nickel fin array followed by the stainless steel 304 and the aluminum arrays. Different failure modes were observed by inspecting the fracture surfaces under Scanning Electron Microscope. Deposition between the cold sprayed nickel and stainless fins was detected whereas dimples were noticed on the substrate between the fins when aluminum is used as the feedstock material. A numerical simulation of normal and angled impacts using the high strain rate Preston-Tonks-Wallace model was carried out in order to have a better understanding of the experimental results. The equivalent plastic strain (PEEQ) obtained from the finite element analysis at normal impact correlates with the different shear strengths measured experimentally. Furthermore, even if a higher PEEQ was observed for angled impacts compared to its normal collision counterpart, it is suggested that the particles may not bond because of the rotational restitution momentum caused by the tangential friction generated during angled impacts. This rotational restitution momentum was not detected for particle impacts normal to the substrate surface.
This work evaluates the thermal and hydrodynamic performance of pyramidal fin arrays produced using cold spray as an additive manufacturing process. Near-net-shaped pyramidal fin arrays of pure aluminum, pure nickel, and stainless steel 304 were manufactured. Fin array characterization such as fin porosity level and surface roughness evaluation was performed. The thermal conductivities of the three different coating materials were measured by laser flash analysis. The results obtained show a lower thermal efficiency for stainless steel 304, whereas the performances of the aluminum and nickel fin arrays are similar. This result is explained by looking closely at the fin and substrate roughness induced by the cold gas dynamic additive manufacturing process. The multi-material fin array sample has a better thermal efficiency than stainless steel 304. The work demonstrates the potential of the process to produce streamwise anisotropic fin arrays as well as the benefits of such arrays.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.