The enhancement of power conversion efficiency (PCE) and the development of toxic Cd-, Pb-free quantum dots (QDs) are critical for the prosperity of QD-based solar cells. It is known that the properties (such as light harvesting range, band gap alignment, density of trap state defects, etc.) of QD light harvesters play a crucial effect on the photovoltaic performance of QD based solar cells. Herein, high quality ∼4 nm Cd-, Pb-free Zn-Cu-In-Se alloyed QDs with an absorption onset extending to ∼1000 nm were developed as effective light harvesters to construct quantum dot sensitized solar cells (QDSCs). Due to the small particle size, the developed QD sensitizer can be efficiently immobilized on TiO2 film electrode in less than 0.5 h. An average PCE of 11.66% and a certified PCE of 11.61% have been demonstrated in the QDSCs based on these Zn-Cu-In-Se QDs. The remarkably improved photovoltaic performance for Zn-Cu-In-Se QDSCs vs Cu-In-Se QDSCs (11.66% vs 9.54% in PCE) is mainly derived from the higher conduction band edge, which favors the photogenerated electron extraction and results in higher photocurrent, and the alloyed structure of Zn-Cu-In-Se QD light harvester, which benefits the suppression of charge recombination at photoanode/electrolyte interfaces and thus improves the photovoltage.

Due to their wide tunable bandgaps, high absorption coefficients, easy solution processabilities, and high stabilities in air, lead sulfide (PbS) quantum dots (QDs) are increasingly regarded as promising material candidates for next-generation light, low-cost, and flexible photodetectors. Current single-layer PbS-QD photodetectors suffer from shortcomings of large dark currents, low on-off ratios, and slow light responses. Integration with metal nanoparticles, organics, and high-conducting graphene/nanotube to form hybrid PbS-QD devices are proved capable of enhancing photoresponsivity; but these approaches always bring in other problems that can severely hamper the improvement of the overall device performance. To overcome the hurdles current single-layer and hybrid PbS-QD photodetectors face, here a bilayer QD-only device is designed, which can be integrated on flexible polyimide substrate and significantly outperforms the conventional single-layer devices in response speed, detectivity, linear dynamic range, and signal-to-noise ratio, along with comparable responsivity. The results which are obtained here should be of great values in studying and designing advanced QD-based photodetectors for applications in future flexible optoelectronics.

The exploration of catalyst materials for counter electrodes (CEs) in quantum dot sensitized solar cells (QDSCs) that have both high electrocatalytic activity and low charge transfer resistance is always significant yet challenging. In this work, we report the incorporation of nitrogen heteroatoms into carbon lattices leading to nitrogen-doped mesoporous carbon (N-MC) materials with superior catalytic activity when used as CEs in Zn-Cu-In-Se QDSCs. A series of N-MC materials with different nitrogen contents were synthesized by a colloidal silica nanocasting method. Electrochemical measurements revealed that the N-MC with a nitrogen content of 8.58 wt % exhibited the strongest activity in catalyzing the reduction of a polysulfide redox couple (S/S), and therefore, the corresponding QDSC device showed the best photovoltaic performance with an average power conversion efficiency (PCE) of 12.23% and a certified PCE of 12.07% under one full sun illumination, which is a new PCE record for quantum dot based solar cells.