Laser communication (lasercom) can enable more efficient links across larger distances compared with radio frequency (RF) systems. However, lasercom systems are typically point-to-point connections that would have difficulty interacting with several concurrently active spatially diverse users, where RF systems can more easily support such scenarios.

Laser crosslinks can provide high data rate communications and precision time transfer and ranging, using low size, weight, and power (SWaP) terminals to enable constellations of small satellites. The CubeSat Laser Infrared CrosslinK (CLICK) mission will demonstrate terminals capable of conducting fullduplex, high data rate crosslinks and enabling high precision ranging on 3U CubeSats in low Earth orbit (LEO). An initial risk reduction mission, CLICK-A, will demonstrate a downlink of at least 10 Mbps to a 28 cm aperture optical ground station. CLICK-B and CLICK-C will follow to demonstrate laser crosslinks with data rates of at least 20 Mbps over separation distances ranging from 25 km to 580 km. The CLICK-B/C mission will also demonstrate precision ranging better than 50 cm. Key to achieving these capabilities are the performances of the transmitter and fine pointing, acquisition, and tracking (PAT) system. We present results from recent testing and characterization of the transmitter and PAT subsystems. The testing of the transmitter includes confirming the output power and modulation of the seed laser and semiconductor optical amplifier (SOA) and characterizing the output pulse shape. For the PAT system, testing focuses on characterizing the noise of the quadrant photodiode used for the closed-loop, fine PAT sequence. This testing was conducted using a dedicated hardware-in-the-loop testbed with an optical test setup. CLICK-A is expected to launch no earlier than May 2022 for deployment from the International Space Station (ISS) in June 2022, while CLICK-B/C is anticipated to launch in late 2022.

Constellations of CubeSats will benefit from high data rate communications links and precision time transfer and ranging. The CubeSat Laser Infrared CrosslinK (CLICK) mission intends to demonstrate low size, weight, and power (SWaP) laser communication terminals, capable of conducting full-duplex high data rate downlinks and crosslinks, as well as high precision ranging and time transfer. A joint project between the Massachusetts Institute of Technology (MIT), the University of Florida (UF), and NASA Ames Research Center, CLICK consists of two separate demonstration flights: the initial CLICK-A, which will demonstrate a space-to-ground downlink and serve as a risk-reduction mission, and CLICK-B/C, a crosslink demonstration mission.The CLICK payloads each consist of laser transceivers and pointing, acquisition, and tracking (PAT) systems, and will fly on 3U CubeSat buses from Blue Canyon Technologies to perform their optical downlink and crosslink experiments in low Earth orbit (LEO). We present an update on the status of both the CLICK-A and CLICK-B/C payloads. At the time of writing, the final assembly and testing of the CLICK-A payload has been completed and the payload has been delivered for integration with the spacecraft bus. The final testing included the validation of the transmitter and the PAT system, the performance of both of which was characterized under various environmental test conditions and shown to meet their requirements for operation on orbit. On CLICK-B/C, the payload electronics have been designed and are under test. The optical bench of the payload has been assembled, the characterization of which is ongoing.

Recent advances in pointing and tracking capabilities of small satellite platforms have enabled adoption of capabilities such as high-resolution Earth Observation (EO), inter-satellite laser communications and, more recently, quantum communications. Quantum communications requires unusually narrow optical beams and tight pointing performance (on the order of ten microradians) to close an inherently brightness-limited quantum link. This limit is due to quantum communication protocols such as quantum key distribution and teleportation requiring individual quantum states to be transmitted with photon number restrictions. We examine an opportunity to combine quantum communications with laser communications in sharing an optical link. We discuss a combined quantum and laser communication terminal capable of performing space-to-ground entanglement-distribution and high data rate communications on a 12U CubeSat with a 95 mm beam expander and an 60 cm aperture optical ground telescope. Photon pairs produced by the quantum terminal are entangled in polarization so the polarization must be maintained throughout the optical link. We discuss active and passive compensation methods in space and polarization reference frame correction using a polarized reference beacon at the ground station. The combined quantum and laser communication terminal approach enables secure communications over an optical channel with rates of 100 Mbps and sub-nanosecond time transfer.

No abstract