The pathological changes in osteoarthritis--a degenerative joint disease prevalent among older people--start at the molecular scale and spread to the higher levels of the architecture of articular cartilage to cause progressive and irreversible structural and functional damage. At present, there are no treatments to cure or attenuate the degradation of cartilage. Early detection and the ability to monitor the progression of osteoarthritis are therefore important for developing effective therapies. Here, we show that indentation-type atomic force microscopy can monitor age-related morphological and biomechanical changes in the hips of normal and osteoarthritic mice. Early damage in the cartilage of osteoarthritic patients undergoing hip or knee replacements could similarly be detected using this method. Changes due to aging and osteoarthritis are clearly depicted at the nanometre scale well before morphological changes can be observed using current diagnostic methods. Indentation-type atomic force microscopy may potentially be developed into a minimally invasive arthroscopic tool to diagnose the early onset of osteoarthritis in situ.

The potentiostatic electrochemical template synthesis of nanowires (Ni, Co, Cu, Au, and polyporrole) in polycarbonate track-etched membranes with nominal pore diameters d N between 10 and 200 nm is studied. Along the wire the cross section is found to vary:  the wire diameter, which is argued to directly reflect the pore diameter, is observed (for all deposits) to be substantially larger in the middle than at both ends. Therefore, the pores are not cylindrical with constant cross-section, in general, but appear to be “cigarlike”. Inside the membrane, the pores are wider by up to a factor 3. Comparing the potentiostatically measured current-time characteristics obtained during wire growth for different pore dimensions, a pore-size dependence of the diffusion coefficient D for the metal ions is found:  D = 2.5, 1.5, and 0.7 × 10-6 cm2/s for d N = 80, 30, and 10 nm, respectively.

The Phoenix mission investigated patterned ground and weather in the northern arctic region of Mars for 5 months starting 25 May 2008 (solar longitude between 76.5 degrees and 148 degrees ). A shallow ice table was uncovered by the robotic arm in the center and edge of a nearby polygon at depths of 5 to 18 centimeters. In late summer, snowfall and frost blanketed the surface at night; H(2)O ice and vapor constantly interacted with the soil. The soil was alkaline (pH = 7.7) and contained CaCO(3), aqueous minerals, and salts up to several weight percent in the indurated surface soil. Their formation likely required the presence of water.

Nanofabricated pores in 20 nm-thick silicon nitride membranes were used to probe various protein analytes as well as to perform an antigen-antibody binding assay. A two-compartment electrochemical cell was separated by a single nanopore, 28 nm in diameter. Adding proteins to one compartment caused current perturbations in the ion current flowing through the pore. These perturbations correlated with both the charge and the size of the protein or of a protein-protein complex. The potential of this nanotechnology for studying protein-protein interactions is highlighted with the sensitive detection of -human chorionic gonadotropin, a hormone and clinical biomarker of pregnancy, by monitoring in real time and at a molecular level the formation of a complex between hormones and antibodies in solution. In this form, the assay compared advantageously to immunoassays, with the important difference that labels, immobilization, or amplification steps were no longer needed. In conclusion, we present proof-of-principle that properties of proteins and their interactions can be investigated in solution using synthetic nanopores and that these interactions can be exploited to measure protein concentrations accurately.The development of more sensitive assays for proteins is highly desirable as it will have a major impact in proteomics (i.e., for the understanding of the role of proteins in complex processes) and in clinical diagnostics (i.e., for alternative test formats). Classic immunoassays, which are routinely used for protein detection, have a sensitivity that is significantly lower than deoxyribonucleic acid (DNA) assays based on an amplification by means of polymerase chain reaction (PCR).1 An elegant way to boost the sensitivity of protein assays is, hence, to use DNA as a label and employ DNA amplification, for example in immuno-PCR 2 or biobarcode assays, 3 which allow a significant decrease in the detection limits to a few tens of proteins.In parallel to these developments, the detection of single biological molecules has become accessible using ultrasensitive fluorescence microscopy, 4-6 which, together with scanning probe microscopy (SPM), 7 is able to reveal inter-and intramolecular interactions and structural information. 8,9 However, the above methods for protein analysis have inherent limitations, such as a requirement for labels, immobilization, or complicated instrumentation that may be overcome with nanoporesensing.10,11 Some unique advantages of using nanopores are (i) no labeling or immobilization of the analyte is necessary; (ii) the instrumental setup is simple and does not require any moving parts, and (iii) it allows real-time detection of the analyte. Nanopores are therefore well suited for studying proteins and interactions between proteins under native conditions and at the single molecule level.Using the biological pore R-hemolysin, Meller et al. could distinguish DNA analytes which only differ in sequence. 11However, biological pores have practical limitations due to operating pH, temperature, a...

We report the detection of protein molecules with nanofabricated pores using the resistive pulse sensing method. A 20-nm-thick silicon nitride membrane with a nanofabricated pore measuring about 55nm in diameter separated an electrolyte cell into two compartments. Current spike trains were observed when bovine serum albumin (BSA) was added to the negatively biased compartment. The magnitude of the spikes corresponded to particles 7–9nm in diameter (the size of a BSA molecule) passing through the pore. This suggests that the current spikes were current blockages caused by single BSA molecules. The presented nano-Coulter counting method could be applied to detect single protein molecules in free solution, and to study the translocation of proteins through a pore.