Recent demands for non-toxic antifouling technologies have led to increased interest in coatings based on silicone elastomers that 'release' macrofouling organisms when hydrodynamic conditions are sufficiently robust. However, these types of coatings accumulate diatom slimes, which are not released even from vessels operating at high speeds (>30 knots). In this study, adhesion strength and motility of three common fouling diatoms (Amphora coffeaeformis var. perpusilla (Grunow) Cleve, Craspedostauros australis Cox and Navicula perminuta Grunow) were measured on a poly-dimethylsiloxane elastomer (PDMSE) and acid-washed glass. Adhesion of the three species was stronger to PDMSE than to glass but the adhesion strengths varied. The wall shear stress required to remove 50% of cells from PDMSE was 17 Pa for Craspedostauros, 24 Pa for Amphora and >>53 Pa for Navicula; the corresponding values for glass were 3, 10 and 25 Pa. In contrast, the motility of the three species showed little or no correlation between the two surfaces. Craspedostauros moved equally well on glass and PDMSE, Amphora moved more on glass initially before movement ceased and Navicula moved more on PDMSE before movement ceased. The results show that fouling diatoms adhere more strongly to a hydrophobic PDMSE surface, and this feature may contribute to their successful colonization of low surface energy, foul-release coatings. The results also indicate that diatom motility is not related to adhesion strength, and motility does not appear to be a useful indicator of surface preference by diatoms.

The adhesive and mechanical properties of a cell-substratum adhesive secreted by live diatom cells were examined in situ using atomic force microscopy. The resulting force curves have a regular saw-tooth pattern, the characteristic fingerprint of modular proteins, and when bridged between tip and surface can repeatedly be stretched and relaxed resulting in precisely overlaying saw-tooth curves (up to approximately 600 successive cycles). The average rupture force of the peaks is 0.794 +/- 0.007 (mean +/- SE) nN at a loading rate of 0.8 microm/s and the average persistence length is 0.026 +/- <0.001 (mean +/- SE) nm (fit using the worm-like chain model). We propose that we are pulling on single adhesive nanofibers, each a cohesive unit composed of a set number of modular proteins aligned in register. Furthermore, we can observe and differentiate when up to three adhesive nanofibers are pulled based upon multimodal distributions of force and persistence length. The high force required for bond rupture, high extensibility (approximately 1.2 microm), and the accurate and rapid refolding upon relaxation, together provide strong and flexible properties ideally suited for the cell-substratum adhesion of this fouling diatom and allow us to understand the mechanism responsible for the strength of adhesion.

A previous study used atomic force microscopy saw-tooth retraction curves to characterize the adhesive mucilage pads of the diatom Toxarium undulatum. The major mucilage component consisted of adhesive nanofibers (ANFs) made up of modular proteins arranged into cohesive units, each containing a set number of modular proteins aligned in parallel. This study shows that T. undulatum adhesive mucilage is a biocomposite containing four additional adhesive components, including single modular proteins that are likely to be the structural units from which the ANFs are assembled. Two further distinct supramolecular assemblies were observed to coexist with ANFs (ANFs II and III), along with a continuum of single modular proteins through oligomers made up of varying numbers of modular proteins arranged in parallel. All components of the adhesive biocomposite produce a characteristic force spectrum with the same interpeak distance (35.3 +/- 0.3 (mean +/- SE) nm), suggesting they are derived from discrete supramolecular assemblies of the same modular protein, but they are distinguishable from one another based on the rupture force, persistence length, and interpeak force measured from their saw-tooth curves.

This Letter reports on adhesive modular proteins recorded by atomic force microscopy on live cells from the extracellular mucilage secreted from, and deposited around, the motile form of the pennate diatom Phaeodactylum tricornutum. This is the first report of modular proteins and their supramolecular assemblies, called adhesive nanofibers (ANFs), to be found on diatoms that use adhesives not only for substratum adhesion, but as a conduit for cell motility. The permanent adhesive pads secreted by Toxarium undulatum, a sessile centric diatom, were previously shown to possess ANFs with a modular protein backbone. Our results reported here suggest that modular proteins may be an important component of diatom adhesives in general, and that diatoms utilize the tensile strength, toughness, and flexibility of ANFs for multiple functions. Significantly, the genome of P. tricornutum has recently been sequenced; this will allow directed searches of the genome to be made for genes with modular protein homologs, and subsequent detailed studies of their molecular structure and function.

The extracellular matrix of the ovoid and fusiform morphotypes of Phaeodactylum tricornutum (Bohlin) was characterized in detail. The structural and nanophysical properties were analyzed by microscopy. Of the two morphotypes, only the ovoid form secretes adhesive mucilage; light microscopy and scanning electron microscopy images showed that the mucilage was secreted from the girdle band region of the cell as cell-substratum tethers, accumulating on the surface forming a biofilm. After 7 d, the secreted mucilage became entangled, forming adhesive strands that crisscrossed the substratum surface. In the initial secreted mucilage atomic force microscopy identified a high proportion of adhesive molecules without regular retraction curves and some modular-like adhesive molecules, in the 7 d old biofilm, the adhesive molecules were longer with fewer adhesive events but greater adhesive strength. Chemical characterization was carried out on extracted proteins and polysaccharides. Differences in protein composition, monosaccharide composition, and linkage analysis are discussed in relation to the composition of the frustule and secreted adhesive mucilage. Polysaccharide analysis showed a broad range of monosaccharides and linkages across all fractions with idiosyncratic enrichment of particular monosaccharides and linkages in each fraction. 3-linked Mannan was highly enriched in the cell frustule fractions indicating a major structural role, while Rhamnose and Fucose derivatives were enriched in the secreted fractions of the ovoid morphotype suggesting involvement in cell adhesion. Comparison of SDS-PAGE of extracellular proteins showed two major bands for the ovoid morphotype and four for the fusiform morphotype of which only one appeared to be common to both morphotypes.