Rectifying nanopores feature ion currents that are higher for voltages of one polarity compared to the currents recorded for corresponding voltages of the opposite polarity. Rectification of nanopores has been found to depend on the pore opening diameter and distribution of surface charges on the pore walls as well as pore geometry. Very little is known, however, on the dependence of ionic rectification on the type of transported ions of the same charge. We performed experiments with single conically shaped nanopores in a polymer film and recorded current–voltage curves in three electrolytes: LiCl, NaCl, and KCl. Rectification degrees of the pores, quantified as the ratio of currents recorded for voltages of opposite polarities, were the highest for KCl and the lowest for LiCl. The experimental observations could not be explained by a continuum modeling based on the Poisson–Nernst–Planck equations. All-atom molecular dynamics simulations revealed differential binding between Li+, Na+, and K+ ions and carboxyl groups on the pore walls, resulting in changes to both the effective surface charge of the nanopore and cation mobility within the pore.

Single pores in the resistive-pulse technique are used as an analytics tool to detect, size, and characterize physical as well as chemical properties of individual objects such as molecules and particles. Each object passing through a pore causes a transient change of the transmembrane current called a resistive pulse. In high salt concentrations when the pore diameter is significantly larger than the screening Debye length, it is assumed that the particle size and surface charge can be determined independently from the same experiment. In this article we challenge this assumption and show that highly charged hard spheres can cause a significant increase of the resistive-pulse amplitude compared to neutral particles of a similar diameter. As a result, resistive pulses overestimate the size of charged particles by even 20%. The observation is explained by the effect of concentration polarization created across particles in a pore, revealed by numerical modeling of ionic concentrations, ion current, and local electric fields. It is notable that in resistive-pulse experiments with cylindrical pores, concentration polarization was previously shown to influence ionic concentrations only at pore entrances; consequently, additional and transient modulation of resistive pulses was observed when a particle entered or left the pore. Here we postulate that concentration polarization can occur across transported particles at any particle position along the pore axis and affect the magnitude of the entire resistive pulse. Consequently, the recorded resistive pulses of highly charged particles reflect not only the particles' volume but also the size of the depletion zone created in front of the moving particle. Moreover, the modeling identified that the effective surface charge density of particles depended not only on the density of functional groups on the particle but also on the capacitance of the Stern layer. The findings are of crucial importance for sizing particles and characterizing their surface charge properties.

Nanopores have become a model system to understand transport properties at the nanoscale. We report experiments and modeling of ionic current in aprotic solvents with different dipole moments through conically shaped nanopores in a polycarbonate film and through glass nanopipettes. We focus on solutions of the salt LiClO4, which is of great importance in modeling lithium based batteries. Results presented suggest ion current rectification observed results from two effects: (i) adsorption of Li(+) ions to the pore walls, and (ii) a finite dipole moment rendered by adsorbed solvent molecules. Properties of surfaces in various solvents were probed by means of scanning ion conductance microscopy, which confirmed existence of an effectively positive surface potential in aprotic solvents with high dipole moments.

Ionic transport at the nanoscale features phenomena that are not observed in larger systems. Nonlinear current− voltage curves characteristic of ionic diodes as well as ion selectivity are examples of effects observed at the nanoscale. Many manmade nanopore systems are inspired by biological channels in a cell membrane, thus measurements are often performed in aqueous solutions. Consequently, much less is known about ionic transport in nonaqueous systems, especially in solid-state electrolytes. Here we show ionic transport through single pores filled with gel electrolyte of poly(methyl methacrylate) (PMMA) doped with LiClO 4 in propylene carbonate. The system has no liquid interface and the ionic transport occurs through the porous gel structure. We demonstrate that a conically shaped nanopore filled with the gel rectifies the current and works as a solid-state ionic diode.