Considerable progress has been made in modelling the response of rivers to tectonic perturbation in order to decode the tectonic signals embedded in river long profiles and planform geometry. Whilst studies have showed the importance of rock type on the morphology of rivers responding to tectonics on a local scale, these effects are often not captured in landscape evolution models. In fact, current models of fluvial response to tectonic perturbation such as active faulting require carefully collected data sets to fully constrain or calibrate key parameters, including the effect of bedrock lithology on substrate erodibility and timescales for tectonic signal propagation in bedrock river systems. Here we constrain the role of bedrock in controlling fluvial incision for a 240 km 2 catchment draining into the Gulf of Corinth, which has excellent tectonic constraints and a variety of bedrock lithologies. An active normal fault at the downstream end of the catchment (the East Eliki Fault) is known to have initiated at 0.7 Ma, with average Quaternary uplift and incision rates of 1.00-1.25 mm/yr. The initiation of the East Eliki Fault is recorded in the river as a prominent knickzone 7-16 km upstream of the fault. Detailed field data collected within this catchment at 500 m intervals along the main channel length at this tectonically wellconstrained field site show an order of magnitude increase in river channel slopes (y/x = 0.02 to 0.18) and stream powers (1 kWm -2 to 27 kWm -2 ) at the lithological boundary between weak and resistant bedrock. The weak conglomerates and strong limestones have Schmidt hammer compressive strengths of ca. 30 and 50 respectively, based on in-situ rock strength measurements. Consequent erodibility values of 1.8 ± 0.3 × 10 -14 and 5 -6 ± 2 × 10 -15 ms 2 kg -1 show a factor of three to four decrease in erodibility for a two-fold increase in rock strength. A simple simulation of tectonic signal propagation through the river catchment based on these erodibility values indicates that the observed plan view position of the knickpoint is consistent with our calculated knickpoint positions based on erodibility values derived from incision rate and stream power data. However, the tectonic signal associated with faulting would have propagated completely through the catchment within 1 Ma if it were entirely composed of weak rock for similar climatic and tectonic conditions, indicating that lithology has a major control on landscape response times.Our results help constrain the effect of lithology on river channel geometry and allow erosional parameters to be derived that are crucial for effective modelling of tectonic rates from topography.

The volume and grain-size of sediment supplied from catchments fundamentally control basin stratigraphy. Despite their importance, few studies have constrained sediment budgets and grain-size exported into an active rift at the basin scale. Here, we used the Corinth Rift as a natural laboratory to quantify the controls on sediment export within an active rift. In the field, we measured the hydraulic geometries, surface grain-sizes of channel bars and full-weighted grain-size distributions of river sediment at the mouths of 47 catchments draining the rift (constituting 83% of the areal extent). Results show that the sediment grain-size increases westward along the southern coast of the Gulf of Corinth, with the coarse-fraction grain-sizes (84 th percentile of weighted grain-size distribution) ranging from approximately 19 to 91 mm. We find that the median and coarse-fraction of the sieved grain-size distribution are primarily controlled by bedrock lithology, with late Quaternary uplift rates exerting a secondary control. Our results indicate that grain-size export is primarily controlled by the input grain-size within the catchment and subsequent abrasion during fluvial transport, both quantities that are sensitive to catchment lithology. We also demonstrate that the median and coarse-fraction of the grain-size distribution are predominantly transported in bedload; however, typical sand-grade particles are transported as suspended load at bankfull conditions, suggesting disparate source-to-sink transit timescales for sand and gravel. Finally, we derive both a full Holocene sediment budget and a grain-size-specific bedload discharged into the Gulf of Corinth using the grain-size measurements and previously published estimates of sediment fluxes and volumes. Results show that the bedload sediment budget is primarily comprised (~79%) of pebble to cobble grade (0.475-16 cm). Our results suggest that the grainsize of sediment export at the rift scale is particularly sensitive to catchment lithology | 1601 EAGE WATKINS eT Al.

How information about sediment transport processes is transmitted to the sedimentary record remains a complex problem for the interpretation of fluvial stratigraphy. Alluvial fan deposits represent the condensed archive of sediment transport, which is at least partly controlled by tectonics and climate. For three coupled catchment‐fan systems in northern Death Valley, California, we measure grain size across 12 well‐preserved Holocene and late‐Pleistocene surfaces, mapped in detail from field observations and remote sensing. Our results show that fan surfaces correlated to the late Pleistocene are, on average, 30–50% coarser than active or Holocene fan surfaces. We adopt a self‐similar form of grain size distribution based on the observed stability of the ratio between mean grain size and standard deviation downstream. Using statistical analysis, we show that fan surface grain size distributions are self‐similar. We derive a relative mobility function using our self‐similar grain size distributions, which describes the relative probability of a given grain size being transported. We show that the largest mobile grain sizes are between 20 and 35 mm, a value that varies over time and is clearly lower in the Holocene than in the Pleistocene; a change we suggest is due to a drier climate in the Holocene. These results support recent findings that alluvial fan sedimentology can record past environmental change and that these landscapes are potentially sensitive to climatic change over a glacial‐interglacial cycle. We demonstrate that the self‐similarity methodology offers a means to explore changes in relative mobility of grain sizes from preserved fluvial deposits.