Co-precipitation is by far the most common synthesis for magnetic iron oxide nanoparticles (IONPs), as cheap and environmentally friendly precursors and simple experimental procedures facilitate IONP production in many labs. Optimising co-precipitation syntheses remains challenging however, as particle formation mechanisms are not well understood. This is partly due to the rapid particle formation (within seconds) providing insufficient time to characterise initial precipitates. To overcome this limitation, a flow chemistry approach has been developed using steady-state operation to "freeze" transient reaction states locally. This allowed for the first time a comprehensive analysis of the early stages of co-precipitation syntheses via in-situ Small Angle X-ray Scattering and in-situ synchrotron X-Ray Diffraction. These studies revealed that after mixing the ferrous/ferric chloride precursor with the NaOH base solution, the most magnetic iron oxide phase forms within 5 s, the particle size changes only marginally afterwards, and co-precipitation and agglomeration occur simultaneously. As these agglomerates were too large to achieve colloidal stability via subsequent stabiliser addition, co-precipitated IONPs had to be de-agglomerated. This was achieved by adding the appropriate quantity of a citric acid solution which yielded within minutes colloidally stable IONP solutions around a neutral pH value. The new insights into the particle formation and the novel stabilisation procedure (not requiring any ultra-sonication or washing step) allowed to design a multistage flow reactor to synthesise and stabilise IONPs continuously with a residence time of less than 5 min. This reactor was robust against fouling and produced stable IONP solutions (of ~ 1.5 mg particles per ml) reproducibly via fast mixing (< 50 ms) and accurate temperature control at large scale (> 500 ml/h) for low materials cost.

Over the past few decades, life cycle assessment (LCA) has been established as a critical tool for the evaluation of the environmental burdens of chemical processes and materials cycles. The increasing amount of plastic solid waste (PSW) in landfills has raised serious concern worldwide for the most effective treatment. Thermochemical post-treatment processes, such as pyrolysis, seem to be the most appropriate method to treat this type of waste in an effective manner. This is because such processes lead to the production of useful chemicals, or hydrocarbon oil of high calorific value (i.e. bio-oil in the case of pyrolysis). LCA appears to be the most appropriate tool for the process design from an environmental context. However, addressed limitations including initial assumptions, functional unit and system boundaries, as well as lack of regional database and exclusion of socio-economic aspects, may hinder the final decision. This review aims to address the benefits of pyrolysis as a method for PSW treatment and raise the limitations and gaps of conducted research via an environmental standpoint.

Highlights A CFD model is developed to simulate microwave heating in a millifluidic channel. The effect of process parameters on the temperature profile are investigated. Satisfactory agreement between modelling and experiments is obtained.

A highly-reproducible, high-yield flow synthesis of gold nanoparticles is developed based on synthesis kinetics from a high-pH gold precursor solution.