No abstract

No abstract

A novel graded material of a high-entropy alloy (HEA) FeCoCrNiMo was fabricated by spark plasma sintering (SPS) processing. After SPS, the HEA specimens consisted of a single face-centred cubic (FCC) phase in the center, but dual FCC and a tetragonal structure σ phase near the surface. Surprisingly, the sintering pressure was sufficient to influence the proportion of phases, and thus the properties of HEA samples. The hardness of the specimens sintered under the pressures of 30, 35, and 40 MPa increased gradually from 210 HV0.2, which is the single FCC phase in the center, to the maximum value near the surface as a result of the gradual increase in the fraction of the transformed σ phase. The σ phase, being a complex hard and brittle intermetallic particle to manipulate the properties of FCC-type HEA systems, which could be influenced by pressure, indicated a major possibility for designing gradient HEA materials.

A high oxygen content can lead to metallurgical defects such as holes and microcracks in the products of selective laser melting (SLM) that significantly reduce the density and mechanical properties of a denture. In this study, a batch of a Co-Cr alloy powder was subjected to forced oxidation. SLM was used to prepare specimens from the powder before and after the treatment for the performance tests. The results showed that Co-Cr alloy powders with oxygen contents 184 and 616 ppm could both achieve good shaping of the specimens under identical SLM conditions. There was no significant difference between the specimens in terms of fuselage morphology, microstructure, density, tensile strength, yield strength and hardness. However, the elongation of the alloy synthesised using the higher oxygen content powder was significantly lowered, but still higher than that required by the ASTM F75 Casting Standard of the United States.

This study reports the results of the addition of diamonds in the sintering process of a FCC-structured CoCrFeNiMo high-entropy alloy. The effect of raw powder states such as elemental mixed (EM) powder, gas atomization (GA) powder and mechanical alloying (MA) powder on the uniformity of constituent phase was also investigated. Examination of microstructure and evaluation of mechanical properties of the composites depending on the mixing processes were performed. As a result, GA+MA powder composite showed the highest mechanical properties. The experimental results indicated that the powder manufacturing method was an essential parameter to determine the quality of HEA/diamond composites such as the uniformity of phase and binding behavior.