The chloric acid method is most commonly used to obtain accurate and reproducible measurements of iodine and removes interfering substances. Unfortunately, chloric acid is a potential hazard requiring an explosion proof hood among other precautions. We have developed a simple, convenient, and economic method for measuring urinary iodine using 1 mol/L ammonium persulfate, a non-explosive, non-hazardous chemical, as the oxidizing reagent. The oxidation procedure can be completed in 30 minutes at a temperature of 91-95 degrees C. The iodine in the urine is then measured by a modification of the traditional colorimetric method of Sandell-Kolthoff. 110 urine samples collected from a mixed population of healthy males and females, ranging in age from 6 to 79 years and living in the United States were analyzed for iodine content by two methods: the proposed ammonium persulfate method and the chloric acid method. The ammonium persulfate method has an intra assay CV of 9.1% at 0.42 +/- 0.04 micromol/L (mean +/- SD), 7.8% at 1.46 +/- 0.11 micromol/L and 4.0% at 3.54 +/- 0.14 micromol/L. The inter assay CV is 10.2% at 0.46 +/- 0.05 micromol/L and 7.9% at 3.27 +/- 0.26 micromol/L. Recovery of iodine added to urine in vitro was 107%, 94% and 97% for 0.42 micromol/L, 0.77 micromol/L and 3.64 micromol/L, respectively. The lower limit of detectability was 0.0034 microgI. Values for iodine in 110 urines measured by the reference chloric acid method ranged from 0.06 to 8.03 micromol/L and by the ammonium persulfate method from 0.05 to 7.4 micromol/L. The persulfate method (y) correlated extremely closely with the reference chloric acid method (x) by the Pearson correlation (y = 0.923x + 0.810 micromol/L, and r = 0.994, Syx = 1.841). In conclusion a new, safe, simple method for measuring urinary iodine is described which uses ammonium persulfate as the oxidizing agent for the removal of interfering substances.
A continuous fixed-bed column study has been used to evaluate phosphate adsorption performance of U-D-Na which was functionalized by the cheap NaCl reagent after simple ultrasonic purification of diatomite. Experimentally, various effect factors, the flow rate, the initial phosphate concentration, and the bed height on breakthrough time of fixed column were studied. Experimental results showed that the breakthrough time declined with the increase of inlet phosphorous concentration and feed rate, whereas the increase of bed height turned out to significantly prolong the breakthrough time. The dynamic adsorption data could better be fitted by the Thomas model, with the correlation coefficients obtained, R 2 >0.9000 at the majority of operating conditions (5/7). At least thrice loop of adsorption and desorption was achieved with 0.1 M hydrochloric acid eluent and deionized water. The results proved that U-D-Na could be used as a better alternative phosphate adsorbent from wastewater in a continuous column process.
A low-cost functionalization method was used to treat diatomite, and an efficient adsorbent for ammonia nitrogen was prepared by optimizing the functionalization conditions. The functionalized diatomite (DTCA-Na) was characterized by SEM, EDS, BET, XRD, FT-IR and TG. The results demonstrate that DTCA-Na has excellent adsorption performance after being modified with H2SO4 (60.00 wt.%), NaCl (5.00 wt.%) and calcination at 400 °C for 2 h. While studying the effect of adsorption factors on the removal of ammonia nitrogen, the kinetic and thermodynamic behaviors in the adsorption process were discussed. The removal efficiency of the simulated wastewater with the initial ammonia nitrogen concentration of 10.00 mg/L by the DTCA-Na was more than 80% when the contact time was 60 min, pH was 6-10, the dosage of adsorbent was 1.00 g, the temperature was 25 °C. The adsorption process of ammonia nitrogen was conformed to the pseudo-first-order and Langmuir isothermal model. The removal efficiency of ammonia nitrogen was still above 80% after 5 times adsorption-desorption experiments. The DTCA-Na has a brighter prospect of application in the field of ammonia nitrogen wastewater treatment due to its excellent adsorption performance and low-cost advantage.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.