No abstract

An intensive field study was conducted in Sumatra, Indonesia, during a peat fire episode to investigate the physical and chemical characteristics of particulate emissions in peat smoke and to provide necessary data for source-receptor analyses. Ambient air sampling was carried out at three different sites located at varying distances from the peatfires to determine changes in mass and number concentrations of PM2.5 and its chemical composition (carbonaceous and nitrogenous materials, polycyclic aromatic hydrocarbons, water-soluble inorganic and organic ions, and total and water-soluble metals). The three sites represent a rural site directly affected by the local peat combustion, a semirural site, and an urban site situated downwind of the peat fires. The mass concentration of PM2.5 and the number concentration of airborne particles were as high as 1600 microg/m3 and 1.7 x 10(5) cm(-3), respectively, in the vicinity of peat fires. The major components of PM2.5 in peat smoke haze were carbonaceous particles, particularly organic carbon, NO3-, and SO4(2-), while the less abundant constituents included ions such as NH4+, NO2-, Na+, K+, organic acids, and metals such as Al, Fe, and Ti. Source apportionment by chemical mass balance receptor modeling indicates that peat smoke can travel long distances and significantly affect the air quality at locations downwind.

No abstract

Hydride generation to form arsine and in-line preconcentration of the arsine into an alkaline KMnO4 receiver followed by molybdenum blue (MB) colorimetric determination of the arsenate formed is proposed for the highly sensitive and separate measurement of total inorganic As and As(III). Reduction of As to AsH3 is carried out by NaBH4; when the reduction is carried out at pH 1, all the inorganic As is reduced to AsH3, and when carried out at pH 7, only As(III) is reduced. Reductions at the two different pH levels are carried out in two different arsine generators simultaneously using constant addition of NaBH4 with solenoid pumps. The AsH3 is collected by individual porous membrane diffusion scrubbers filled with a stationary solution of KMnO4, and the contents of the two scrubbers sequentially enter a flow analysis stream. MB is formed by merging with a ammonium molybdate-ascorbic acid reagent, passing through a heated reactor, and is then measured by a LED/photodiode-based absorbance detector. Robustness was confirmed for total As using three types of certified natural water samples. Speciation analysis data from well water samples analyzed by this method agree well with HPLC-ICPMS measurements in a different laboratory. The system has been successfully applied to field measurements of As(III) and As(V), where levels were significantly below 1 mug/L. For a 20-mL sample, the limits of detection (LODs) for this inexpensive instrument are 0.3 microg/L for both As(III) and total As. When an 80-mL sample is analyzed, LODs are 0.07 microg/L As(III) and 0.09 microg/L total As. The general approach should be applicable to many other analyte species of interest that can be isolated from the matrix by the formation of a suitable volatile compound that can be recaptured.