An eddy-viscosity based, subgrid-scale model for Large Eddy Simulations is derived from the analysis of the singular values of the resolved velocity gradient tensor. The proposed σ-model has by construction the property to automatically vanish as soon as the resolved field is either two-dimensional or two-component, including the pure shear and solid rotation cases. In addition, the model generates no subgrid-scale viscosity when the resolved scales are in pure axisymmetric or isotropic contraction/expansion. At last, it is shown analytically that it has the appropriate cubic behavior in the vicinity of solid boundaries without requiring any ad-hoc treatment. Results for two classical test cases (decaying isotropic turbulence and periodic channel flow) obtained from three different solvers with a variety of numerics (finite elements, finite differences or spectral methods) are presented to illustrate the potential of this model. The results obtained with the proposed model are systematically equivalent or slightly better than the results from the Dynamic Smagorinsky model. Still, the σ-model has a low computational cost, is easy to implement and does not require any homogeneous direction in space or time. It is thus anticipated that it has a high potential for the computation of non-homogeneous, wall-bounded flows.

Large-eddy simulation (LES) has proven to be a computationally tractable approach to simulate unsteady turbulent flows. However, prohibitive resolution requirements induced by near-wall eddies in high-Reynolds number boundary layers necessitate the use of wall models or approximate wall boundary conditions. We review recent investigations in wall-modeled LES, including the development of novel approximate boundary conditions and the application of wall models to complex flows (e.g., boundary-layer separation, shock/boundary-layer interactions, transition). We also assess the validity of underlying assumptions in wall-model derivations to elucidate the accuracy of these investigations, and offer suggestions for future studies.

We describe and characterize a method for estimating the pressure field corresponding to velocity field measurements such as those obtained by using particle image velocimetry. The pressure gradient is estimated from a time series of velocity fields for unsteady calculations or from a single velocity field for quasi-steady calculations. The corresponding pressure field is determined based on median polling of several integration paths through the pressure gradient field in order to reduce the effect of measurement errors that accumulate along individual integration paths. Integration paths are restricted to the nodes of the measured velocity field, thereby eliminating the need for measurement interpolation during this step and significantly reducing the computational cost of the algorithm relative to previous approaches. The method is validated by using numerically simulated flow past a stationary, two-dimensional bluff body and a computational model of a three-dimensional, selfpropelled anguilliform swimmer to study the effects of spatial and temporal resolution, domain size, signal-to-noise ratio and out-ofplane effects. Particle image velocimetry measurements of a freely swimming jellyfish medusa and a freely swimming lamprey are analyzed using the method to demonstrate the efficacy of the approach when applied to empirical data.

Wall models for large-eddy simulation (LES) are a necessity to remove the prohibitive resolution requirements of near-wall turbulence in high Reynolds turbulent flows. Traditional wall models often rely on assumptions about the local state of the boundary layer (e.g., logarithmic velocity profiles) and require a priori prescription of tunable model coefficients. In the present study, a slip velocity boundary condition for the filtered velocity field is obtained from the derivation of the LES equations using a differential filter. A dynamic procedure for the local slip length is additionally formulated making the slip velocity wall model free of any a priori specified coefficients. The accuracy of the dynamic slip velocity wall model is tested in a series of turbulent channel flows at varying Reynolds numbers and in the LES of a National Advisory Committee for Aeronautics (NACA) 4412 airfoil at near-stall conditions. The wall-modeled simulations are able to accurately predict mean flow characteristics, including the formation of a trailing-edge separation bubble in NACA 4412 configuration. The validation cases demonstrate the effectiveness of this wall-modeling approach in both attached and separated flow regimes.