IFMIF, the International Fusion Materials Irradiation Facility, is presently in its engineering validation and engineering design activities (EVEDA) phase under the Broader Approach Agreement. The engineering design activity (EDA) phase was successfully accomplished within the allocated time. The engineering validation activity (EVA) phase has focused on validating the Accelerator Facility (AF), the Target Facility and the Test Facility (TF) by constructing prototypes. The ELTL at JAEA, Oarai successfully demonstrated the long-term stability of a Li flow under the IFMIF’s nominal operational conditions keeping the specified free-surface fluctuations below  ±1 mm in a continuous manner for 25 d. A full-scale prototype of the high flux test module (HFTM) was successfully tested in the HELOKA loop (KIT, Karlsruhe), where it was demonstrated that the irradiation temperature can be set individually and kept uniform. LIPAc, designed and constructed in European labs under the coordination of F4E, presently under installation and commissioning in the Rokkasho Fusion Institute, aims at validating the concept of IFMIF accelerators with a D+ beam of 125 mA continuous wave (CW) and 9 MeV. The commissioning phases of the H+/D+ beams at 100 keV are progressing and should be concluded in 2017; in turn, the commissioning of the 5 MeV beam is due to start during 2017. The D+ beam through the superconducting cavities is expected to be achieved within the Broader Approach Agreement time frame with the superconducting cryomodule being assembled in Rokkasho. The realisation of a fusion-relevant neutron source is a necessary step for the successful development of fusion. The ongoing success of the IFMIF/EVEDA involves ruling out concerns about potential technical showstoppers which were raised in the past. Thus, a situation has emerged where soon steps towards constructing a Li(d,xn) fusion-relevant neutron source could be taken, which is also justified in the light of costs which are marginal to those of a fusion plant.

The need of a neutron source for the qualification of materials to be used in future fusion power reactors have been recognized in the European (EU) fusion programme since many years. The construction and exploitation of this facility is presently considered to be in the critical path of DEMO. This issue prompted the EU to launch activities for the design and engineering of the IFMIF-DONES (International Fusion Materials Irradiation Facility-DEMO Oriented Neutron Source) facility based on and taking profit of the results obtained in the IFMIF/EVEDA ('Engineering Validation and Engineering Design Activities') project, presently conducted in the framework of the EU-Japan Bilateral Agreement on the Broader Approach to Fusion. These activities and R&D work for the IFMIF-DONES Plant are presently taking place in the framework of a work package of the 'EUROfusion' Consortium, in direct collaboration with 'Fusion for Energy' Organization. The main objective of these activities is to consolidate the design and the underlying technology basis in order to be ready for IFMIF-DONES construction as early as possible. The paper presents the main engineering results for a generic site obtained during the first years of design work, as indicated in the recently released IFMIF-DONES Preliminary Engineering Design Report, making emphasis on the design evolution from previous phases and on the critical issues to be further developed in the near future. The proposed European site to host the facility (Granada Spain) is briefly introduced as well.