We demonstrate a highly efficient thermal conversion of four differently substituted polydiacetylenes (PDAs 1 and 2a-c) into virtually indistinguishable N = 8 armchair graphene nanoribbons ([8]GNR). PDAs 1 and 2a-c are themselves easily accessed through photochemically initiated topochemical polymerization of diynes 3 and 4a-c in the crystal. The clean, quantitative transformation of PDAs 1 and 2a-c into [8]GNR occurs via a series of Hopf pericyclic reactions, followed by aromatization reactions of the annulated polycyclic aromatic intermediates, as well as homolytic bond fragmentation of the edge functional groups upon heating up to 600 °C under an inert atmosphere. We characterize the different steps of both processes using complementary spectroscopic techniques (CP/MAS C NMR, Raman, FT-IR, and XPS) and high-resolution transmission electron microscopy (HRTEM). This novel approach to GNRs exploits the power of crystal engineering and solid-state reactions by targeting very large organic structures through programmed chemical transformations. It also affords the first reported [8]GNR, which can now be synthesized on a large scale via two operationally simple and discrete solid-state processes.

Rubin and colleagues describe the development of a simple, bottom-up synthetic approach to graphene nanoribbons (GNRs). In contrast to current methods, this process requires only two solid-state transformations. The key to this approach is the in-crystal topochemical polymerization of butadiyne-containing monomers to produce the corresponding polydiacetylene polymers. These polymers are subsequently fully aromatized in the solid state to GNRs at relatively mild temperatures.

Three‐dimensional (3D) printing brings exciting prospects to the realm of conjugated polymers (CPs) and organic electronics through vastly enhanced design flexibility, structural complexity, and environmental sustainability. However, the use of 3D printing for CPs is still in its infancy and remains full of challenges. In this review, we highlight recent studies that demonstrate proof‐of‐concept strategies to mitigate some of these problems. Two general additive manufacturing approaches are featured: direct ink writing and vat photopolymerization. We conclude with an outlook for this thriving field of research and draw attention to the new possibilities that 3D printing can bring to CPs. © 2019 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2019, 57, 1592–1605

Rationally designed, 3D-printed architectures can effectively decouple the mechanical and electrical properties of conducting polymer hydrogels.