Acute acromioclavicular (AC) joint dislocation is a frequent sports injury with more than 100 different operation methods described. A total of 65 patients with an acute AC joint dislocation were treated with the modified MINAR® system between 2009 and 2013. Clinical outcome, horizontal and vertical instability, as well as concomitant intraarticular injuries were assessed. We used Zanca, stress and axial X-rays for radiological assessment. A Constant score of 95 (±8.8), University of California Los Angeles Shoulder score (UCLA) of 31 (±4.9), Disabilities of Arm, Shoulder and Hand (DASH) of 9.1 (±14.3), and Visual Analogue Scale (VAS) of 0.9 (±0.126) was found. A total of 30 patients (59%) had no signs of reduction loss, nine patients (18%) a slight loss, 11 patients (22%) a partial loss, and one patient (2%) a total loss. No significant influence on the clinical scores could be shown. The postoperative coracoclavicular (CC) distance negatively affected the Constant (p = 0.007) and UCLA scores (p = 0.035). A longer time interval to surgery had a negative influence on all scores (p ≤ 0.001). We could not find any signs of persistent horizontal instability or intraarticular injuries at follow-up. The MINAR® system promises satisfactory functional and radiological results. When setting the correct indication, patients benefit from an early operation. No persisting horizontal instability was observed following suturing of the AC capsule and the delta fascia.

The best intramedullary nail for the treatment of unstable AO/OTA 31.A2.1-3 fractures remains uncertain. A total of 237 patients (45 male, 192 female) were eligible for the assessment with an average age of 81.9 ± 10.5 years and a minimum follow-up of six months. We assessed the cut-out rate, the TAD and calTAD (Tip Apex distance) of three different implants. An overall cut-out rate of 2.5% (n = 6) was observed. The cut-out rate was 1.2% (n = 1) in the Proximal Femur Nail Antirotation (PFNA) group, 3.7% (n = 3) in the Gamma Nail group and 2.9% (n = 2) in the Gamma3® with a U-Blade (RC) lag-screw group. The TAD and calTAD differed between the cut-out and non-cut group—20.0 mm vs. 18.5 mm and 13.1 mm vs. 15.3 mm, respectively. A significantly higher TAD of 32.5 mm could be seen in the cut-out after PFNA (p < 0.0001). The only significant change in follow-up using Parker’s ratio was observed in the PFNA group (p < 0.0001). The rate of patients requiring surgery after complications was 8.4% (n = 20) without any significant difference between the three groups. The PFNA blade showed significant migration within the femoral head, however the cut-out rate remained the smallest compared to Gamma3 with or without additional U-Blade (RC) lag screw.

Background: Distal first metatarsal osteotomies are commonly performed operative procedures for hallux valgus deformity, and usually involve fixation with a metal screw. However, various bioabsorbable osteosynthesis materials have been in use for a number of years. One recent innovation is the Shark Screw®, a human cortical bone allograft. This study aimed to evaluate the efficacy and safety of this allogeneic screw in the stabilization of Reversed L-Shaped osteotomy, a modified Chevron osteotomy. Methods: In a prospective study, 15 patients underwent a Reversed L-Shaped osteotomy stabilized with the allogenic bone screw Radiological data on osteointegration of the screw and correction of the intermetatarsal angle were recorded. Furthermore, each follow-up examination included the collection of clinical data, the American Orthopedic Foot and Ankle Society (AOFAS) score, evaluation of pain level, and patient’s overall satisfaction. Results: Full osseous fusion of the osteotomy was seen in all patients. The bone screws were radiographically integrated after approximately 6.5 (±2.6) months. Neither nonunion nor failure occurred in any of our cases. Furthermore, we did not find any potential graft reaction. The AOFAS score improved significantly from 51.6 (±15.2) points to 90.9 (±10.3) (p < 0.001). The preoperative hallux valgus angle and intermetatarsal angle decreased significantly from 24.8 (±4.9) degrees to 7.2 (±4.4) degrees (p < 0.001) and 12.6 (±3.2) degrees to 4.8 (±1.3) degrees (p < 0.001), respectively. Conclusions: With this study, we demonstrated the efficiency of the allogenic bone screw (Shark Screw®) in regard to clinical and radiological short-term outcomes.

Background: Symptomatic osteochondral lesions of the talus (OLTs) often require surgical intervention. There are various surgical methods. A generally valid, stage-dependent therapeutic algorithm does not exist. The aim of our study is to show long- term results of an alternative technique that combines retrograde drilling, debridement performed under arthroscopic visualization, and autologous bone grafting. Methods: The surgical technique was performed in 24 patients with medial or lateral OLTs, and the data were analyzed retrospectively. In our technique, the affected subchondral bone was overdrilled retrogradely and resected under arthroscopic visualization (ossoscopy) without violating the cartilage. The resulting defect was filled with autologous bone from the medial tibia metaphysis. Outcome parameters were the numeric rating scale (NRS), the American Orthopaedic Foot & Ankle Society (AOFAS) ankle-hindfoot score, and range of motion (ROM). The Magnetic Resonance Observation of Cartilage Repair Tissue (MOCART) score was assessed and a possible correlation with the clinical outcome scores was calculated. Data concerning complication rates were also collected. Results: The mean surface size of the OLTs was 0.9 ± 0.3 cm2. The mean follow-up was 89 months. The AOFAS score improved significantly from 57.7 points preoperatively to 88.8 points at the final follow-up ( P < .0001). The pain value measured by the NRS decreased significantly from 8 to a pain level of 2. ROM improved in 37.5% of the patients for dorsiflexion and 29.2% for plantarflexion. There were no significant correlations between the MOCART score and the AOFAS score or the pain value on NRS. Conclusion: Retrograde drilling, ossoscopy, and autologous bone grafting for OLTs is a promising technique with good long-term results. The patients’ satisfaction rate, especially in OLT stages 2 and 3, was excellent. Level of Evidence: Level IV, case series.

No abstract