The design and fabrication of a 32 T, 32 mm cold bore superconducting magnet with high field REBCO inner coils is underway at the NHMFL. In support of the design, conductor characterization measurements have been made including critical current as a function of field, field orientation, temperature, and strain on conductors and joints. Various conductor and turn insulation systems were examined. The selected coil fabrication method for the 32 T magnet is pancake wind, dry wind coils with sol-gel insulation on a stainless steel co-wind. Quench protection of the REBCO coils by distributed heaters is under development. Small REBCO coils have been made and tested in a 20 T background field to demonstrate performance of the technology. The design of the 32 T magnet is described, including coil configuration and conductor lengths, fraction of critical current, selection of conductor copper content for protection, and stress in the windings.Index Terms-High field superconducting magnets, insulation, quench protection, REBCO.

Large-grain Nb has become a viable alternative to fine-grain Nb for the fabrication of superconducting radio-frequency cavities. In this contribution we report the results from a heat treatment study of a large-grain 1.5 GHz single-cell cavity made of "medium purity" Nb. The baseline surface preparation prior to heat treatment consisted of standard buffered chemical polishing. The heat treatment in the range 800 -1400 • C was done in a newly designed vacuum induction furnace. Q0 values of the order of 2 × 10 10 at 2.0 K and peak surface magnetic field (Bp) of 90 mT were achieved reproducibly. A Q0-value of (5 ± 1) × 10 10 at 2.0 K and Bp = 90 mT was obtained after heat treatment at 1400 • C. This is the highest value ever reported at this temperature, frequency and field. Samples heat treated with the cavity at 1400 • C were analyzed by secondary ion mass spectrometry, secondary electron microscopy, energy dispersive X-ray, point contact tunneling and X-ray diffraction and revealed a complex surface composition which includes titanium oxide, increased carbon and nitrogen content but reduced hydrogen concentration compared to a non heat-treated sample.

Screening currents and their effect on the magnetic field and strain state have been shown to be a major problem in the design and operation of rare-earth-barium-copper-oxide magnets, distorting the field and rotating the conductor to potentially large strains. The latter is a possible catalyst for damage as both plastic deformation and degradation of the critical current leading to reduced fatigue life or even catostrophic failure. Due to the nonlinear dynamic behavior of the screening currents and the significant possible rotation, including this rotational effect in the electromagnetic state requires a new addition to the existing models. The effect of the changing rotation angle of the conductor on the electromagnetic and stress state is investigated by using a modified homogeneous T–A method. Numerical results are compared with experimental tests.