Gold nanorods (GNRs) were used as a saturable absorber (SA) for passive mode-locking at 1 µm wavelength. The GNR-SA film was fabricated by mixing GNRs with sodium carboxymethylcellulose. The longitudinal surface plasmon resonance absorption of GNRs was used to induce mode-locking. By using the GNR-SA film, stable passive mode-locking at 1039 nm was experimentally demonstrated in an ytterbium-doped fiber laser cavity pumped by a 980 nm laser diode. The laser produced ∼440 ps pulses with a repetition rate of 36.6 MHz and an average output power of ∼1.25 mW for a pump power of ∼82 mW.
This study shows the ability of sodium-glucose co-transporter-2 inhibitors to lower atrial natriuretic peptide levels and improve glycaemic control, which may benefit the cardiovascular system.
Recently, theoretical studies show that layered HfTe5 is at the boundary of weak & strong topological insulator (TI) and might crossover to a Dirac semimetal state by changing lattice parameters. The topological properties of 3D stacked HfTe5 are expected hence to be sensitive to pressures tuning. Here, we report pressure induced phase evolution in both electronic & crystal structures for HfTe5 with a culmination of pressure induced superconductivity. Our experiments indicated that the temperature for anomaly resistance peak (Tp) due to Lifshitz transition decreases first before climbs up to a maximum with pressure while the Tp minimum corresponds to the transition from a weak TI to strong TI. The HfTe5 crystal becomes superconductive above ~5.5 GPa where the Tp reaches maximum. The highest superconducting transition temperature (Tc) around 5 K was achieved at 20 GPa. Crystal structure studies indicate that HfTe5 transforms from a Cmcm phase across a monoclinic C2/m phase then to a P-1 phase with increasing pressure. Based on transport, structure studies a comprehensive phase diagram of HfTe5 is constructed as function of pressure. The work provides valuable experimental insights into the evolution on how to proceed from a weak TI precursor across a strong TI to superconductors.
We numerically investigated widely tunable femtosecond solitons spanning from 4.1 to 7.2 µm in designed chalcogenide fibers with two rings of air holes. The core was made of Ge 15 Sb 15 Se 70 glass and the cladding glass was composed of Ge 20 As 15 S 65 . By using a 4.1 µm fiber laser with a pulse width of 100 fs as the pump light and 1 m long chalcogenide microstructured fibers as the nonlinear media, widely tunable femtosecond solitons spanning from 4.1 to 7.2 µm were observed, and the pulse width of these tunable Raman solitons remained below 150 fs. The efficiencies of the mid-infrared soliton could be up to over 80%, ranging from 4.1-6.8 µm. Through numerical simulations, we also observed red-shifted dispersive waves varying from 10.2 to 8.9 µm. Our simulated results show that the designed chalcogenide microstructured fibers are promising nonlinear media for generating tunable mid-infrared light sources.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.