A case of a 42-year-old male patient with symptomatic juxtaarticular osteoid osteoma of the capitulum humeri is presented. After the clinical diagnosis was confirmed with plain radiographs, bone scan, computer tomography and magnetic resonance imaging, the patient underwent arthroscopic removal of the lesion. A partial synoviectomy was performed first and then the center of the lesion was marked with Kirschner wire using the X-ray monitoring. The marked lesion was transarticularly removed with a motorized shaver device. Post-operatively, the patient reported prompt relief of pain that had not reoccurred during 1 year of follow up. To the authors' knowledge, this is the first report of the arthroscopic removal of juxtaarticular osteoid osteoma of the humeral capitulum which promises to be an effective and less invasive alternative to the existing treatment options.
We determined contact stress on the articular surface of the hip joint in a group of patients who underwent operative treatment for severe slipped capital femoral epiphysis. Two different procedures were considered: the modified osteotomy of Dunn-Fish and the osteotomy of Imhäuser. In order to determine the stress distribution, a three-dimensional mathematical model was used taking into account the geometrical parameters of the pelvis and hip, which were measured from standard antero-posterior radiographs. We found that the Dunn-Fish procedure produced lower peak stress than the Imhäuser procedure.Résumé Nous avons determiné la pression sur la surface articulaire de la hanche dans un groupe de patients operés pour épiphysiolyse femorale supérieure. Deux opérations ont été considereés: l'opération de Dunn-Fish modifieé et l'ostéotomie d'Imhäuser. Pour déterminer la distribution des pressions, un modèle mathématique tridimensionel a été employé, tenant compte des paramétres géometriques du bassin et de la hanche, obtenus à partir des clichés antéro-postérieurs. Nous avons trouvé que dans les hanches opérées par la procedure de DunnFish modifiée les pics de pression sont inférieurs à ceux dans les hanches opérées par la technique d'Imhäuser.
The biomechanical state of the hip after a Salter innominate osteotomy was investigated by using the radiographic data of 38 operated and 21 contralateral nonoperated hips from our archives. The centre-edge angle of Wiberg was determined from the radiographs taken shortly after the operation. From the radiographs of the latest follow-up (7-13 years after the operation), we also determined the peak value of contact hip joint stress normalized by the body weight, and the functional angle of the weight-bearing area. A mathematical model was used. We show that the geometrical parameters aside from the centre-edge angle may considerably influence the contact hip stress distribution. We also show that the functional angle of the weight-bearing area is a more relevant parameter than the normalized peak stress if the exact magnification of the images is not known and if there is considerable variation of the image size within the sample. The development of the centre-edge angle of the operated hips and of the contralateral hips was also studied. We found that the centre-edge angle increases on average during the follow-up time in the operated hips as well as in the contralateral nonoperated hips, but the average increase is smaller in the former. It is shown that an unfavorable stress distribution is connected to the decrease of the centre-edge angle over time. Finally, we found a weak positive correlation between the centre-edge angle shortly after the operation and the functional angle of the weight-bearing area at the of the latest follow-up.
Introduction There is no evidence that anatomically correct anterior cruciate ligament reconstruction (ACLR) offers lower rate of degenerative changes development or that it would lead to a better outcome. The significance and understanding of the abnormal anterior tibial translation (ATT) in ACLR patients is yet to be established. Methods Sixty subjects (40 patients at 5.9 years after ACLR, 20 healthy controls) underwent 3 T MRI. Quantitative cartilage T2 mapping and morphological whole organ magnetic resonance imaging score (WORMS) evaluation was performed. Self-reported questionnaires were used for subjective clinical evaluation. Correlations were calculated with the following MRI measurements; femoral tunnel inclination, ACL graft inclination, lateral and medial compartment ATT. Results In the ACLR group positive correlation was found between the patellar cartilage T2 values and sagittal ACL graft inclination. In the ACLR group lateral compartment ATT showed negative correlation with ACL graft inclination and subjective clinical evaluation, and positive correlation with morphological degenerative changes. Femoral tunnel showed positive correlation with ACL graft inclination in the same plane. Conclusions Increased ATT offers worse clinical outcome and increased rate of degenerative changes. Furthermore, ATT is affected by the ACL inclination. Inclination of the drilling tunnel affects ACL graft inclination; thereby independent drilling techniques provide superior results of anatomical ACL graft positioning.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.