T2K (Tokai to Kamioka) is a long baseline neutrino experiment with the primary goal of measuring the neutrino mixing angle θ 13 . It uses a muon neutrino beam, produced at the J-PARC accelerator facility in Tokai, sent through a near detector complex on its way to the far detector, Super-Kamiokande. Appearance of electron neutrinos at the far detector due to oscillation is used to measure the value of θ 13 .

The T2K experiment is a long baseline neutrino oscillation experiment. Its main goal is to measure the last unknown lepton sector mixing angle θ13θ13 by observing νeνe appearance in a νμνμ beam. It also aims to make a precision measurement of the known oscillation parameters, View the MathML sourceΔm232 and sin22θ23sin22θ23, via νμνμ disappearance studies. Other goals of the experiment include various neutrino cross-section measurements and sterile neutrino searches. The experiment uses an intense proton beam generated by the J-PARC accelerator in Tokai, Japan, and is composed of a neutrino beamline, a near detector complex (ND280), and a far detector (Super-Kamiokande) located 295 km away from J-PARC. This paper provides a comprehensive review of the instrumentation aspect of the T2K experiment and a summary of the vital information for each subsystem

We report a measurement of muon-neutrino disappearance in the T2K experiment. The 295-km muon-neutrino beam from Tokai to Kamioka is the first implementation of the off-axis technique in a long-baseline neutrino oscillation experiment. With data corresponding to 1.43×10 20 protons on target, we observe 31 fully-contained single µ-like ring events in Super-Kamiokande, compared with an expectation of 104 ± 14 (syst) events without neutrino oscillations. The best-fit point for two-flavor νµ → ντ oscillations is sin 2 (2θ23) = 0.98 and |∆m 2 32 | = 2.65 × 10 −3 eV 2 . The boundary of the 90% confidence region includes the points (sin 2 (2θ23), |∆m 2 32 |) = (1.0, 3.1×10 −3 eV 2 ), (0.84, 2.65×10 −3 eV 2 ) and (1.0, 2.2×10 −3 eV 2 ).

Precise measurement of neutrino beam direction and intensity was achieved based on a new concept with modularized neutrino detectors. INGRID (Interactive Neutrino GRID) is an on-axis near detector for the T2K long baseline neutrino oscillation experiment. INGRID consists of 16 identical modules arranged in horizontal and vertical arrays around the beam center. The module has a sandwich structure of iron target plates and scintillator trackers. INGRID directly monitors the muon neutrino beam profile center and intensity using the number of observed neutrino events in each module. The neutrino beam direction is measured with accuracy better than 0.4 mrad from the measured profile center. The normalized event rate is measured with 4% precision

A neutrino experiment facility using the J-PARC proton beam has been constructed at Tokai campus of KEK. In this project, a 150 m superconducting magnet system is installed in an arc section of the primary proton beam line. The magnet system consists of 28 superconducting magnets. The cold mass of a magnet is 6 tons. The refrigerator and the magnets are connected by a transfer tube with the total length of 90 m. Forced flow supercritical Helium with the mass flow rate of 300 g/sec, the inlet temperature of 4.5 K and inlet pressure of 400 kPa is supplied to the magnets through the transfer tube. A pair of superconducting busbars are also installed in the transfer tube. Total cold mass of the magnet system including the transfer tube and other instruments is about 204 tons. This paper describes the cryogenic performance of the superconducting magnet system.