Evaporative cooling systems in buildings have been criticized for their water use and acclaimed for their low energy consumption, especially when compared to typical cooling systems. In order to determine the overall effectiveness of cooling systems in buildings, both water and energy need to be considered; however, there must be a metric to compare the amount of energy used at the site to the amount of water used at the power plant.A study of power plants and their respective water consumption was completed to effectively analyze evaporative cooling systems. Eighty-nine percent of electricity in the United States is produced with thermally driven water-cooled energy conversion cycles. Thermoelectric power plants withdraw a tremendous amount of water, but only a small percentage is evaporated. The evaporative or consumptive use1 is approximately 2.5% or 3,310 million gal per day (MGD) (12,530 x 10 6 L/d). Moreover, hydroelectric plants produce approximately 9% of the nation's electricity. Evaporative water loss from the reservoir surfaces also results in water being evaporated for electrical production.In thermoelectric plants, 0.47 gal (1.8 L) of fresh water is evaporated per kWh of electricity consumed at the point of end use. Hydroelectric plants evaporate an average of 18 gal (68 L) of fresh water per kWh used by the consumer. The national weighted average for thermoelectric and hydroelectric water use is 2.0 gal (7.6 L) of evaporated water per kWh of electricity consumed at the point of end use. From this information, different types of building cooling systems can be compared for relative water consumption. This paper will aid in High Performance Building research by providing a metric in determining water efficiency in building cooling systems. Further analysis is planned to determine the overall water efficiency of evaporative cooling systems compared to conventional direct expansion systems and chiller systems with cooling towers.
This report uses EnergyPlus simulations of each building in the 2003 Commercial Buildings Energy Consumption Survey (CBECS) to document and demonstrate bottom-up methods of modeling the entire U.S. commercial buildings sector (EIA 2006). The ability to use a whole-building simulation tool to model the entire sector is of interest because the energy models enable us to answer subsequent "what-if" questions that involve technologies and practices related to energy. This report documents how the whole-building models were generated from the building characteristics in 2003 CBECS and compares the simulation results to the survey data for energy use.
Commercial buildings have a significant impact on energy use and the environment. They account for approximately 18% (17.9 quads) of the total primary energy consumption in the United States (DOE 2005). The energy used by the building sector continues to increase, primarily because new buildings are added to the national building stock faster than old buildings are retired. Energy consumption by commercial buildings will continue to increase until buildings can be designed to produce more energy than they consume. As a result, the U.S. Department of Energy's (DOE) Building Technologies Program has established a goal to create the technology and knowledgebase for marketable zero-energy commercial buildings (ZEBs) by 2025. To help DOE reach its ZEB goal, the Buildings and Thermal Systems Center at the National Renewable Energy Laboratory (NREL) studied six buildings in detail over the past four years to understand the issues related to the design, construction, operation, and evaluation of the current generation of lowenergy commercial buildings. These buildings and the lessons learned from them help inform a set of best practices-beneficial design elements, technologies, and techniques that should be encouraged in future buildings, as well as pitfalls to be avoided. The lessons learned from these six buildings are also used to guide future research on commercial buildings to meet DOE's goal for facilitating marketable ZEBs by 2025. The six buildings are:
We conducted simulation-based research to study the energy impacts of outside air on U.S. commercial buildings stock. We derived detailed building models from 4,820 buildings in the 2003 Commercial Buildings Energy Consumption Survey (CBECS). Combined with the appropriate weighting factors these 4,820 models form the basis of this national scale study. The energy effects of outside air on commercial buildings were analyzed according to three types of construction. • The commercial sector was analyzed based on a set of models called the Existing Stock Construction Group, which is designed to represent the current CBECS buildings.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.