The self-assembly of a series of hexadehydrotribenzo[12]annulene (DBA) derivatives has been scrutinized by scanning tunneling microscopy (STM) at the liquid-solid interface. First, the influence of core symmetry on the network structure was investigated by comparing the two-dimensional (2D) ordering of rhombic bisDBA 1a and triangular DBA 2a (Figure 1). BisDBA 1a forms a Kagomé network upon physisorption from 1,2,4-trichlorobenzene (TCB) onto highly oriented pyrolytic graphite (HOPG). Under similar experimental conditions, DBA 2a shows the formation of a honeycomb network. The core symmetry and location of alkyl substituents determine the network structure. The most remarkable feature of the DBA networks is the interdigitation of the nonpolar alkyl chains: they connect the pi-conjugated cores and direct their orientation. As a result, 2D open networks with voids are formed. Second, the effect of alkyl chain length on the structure of DBA patterns was investigated. Upon increasing the length of the alkyl chains (DBAs 3c-e) a transition from honeycomb networks to linear networks was observed in TCB, an observation attributed to stronger molecule-substrate interactions. Third, the effect of solvent on the structure of the nonpolar DBA networks was investigated in four different solvents: TCB as a polar aromatic solvent, 1-phenyloctane as a solvent having both aromatic and aliphatic moieties, n-tetradecane as an aliphatic solvent, and octanoic acid as a polar alkylated solvent. The solvent dramatically changes the structure of the DBA networks. The solvent effects are discussed in terms of factors that influence the mobility of molecules at the liquid-solid interface such as solvation.
m-Diethynylbenzene macrocycles (DBMs), buta-1,3-diyne-bridged [4(n)]metacyclophanes, have been synthesized and their self-association behaviors in solution were investigated. Cyclic tetramers, hexamers, and octamers of DBMs having exo-annular octyl, hexadecyl, and 3,6,9-trioxadecyl ester groups were prepared by intermolecular oxidative coupling of dimer units or intramolecular cyclization of the corresponding open-chain oligomers. The aggregation properties were investigated by two methods, the (1)H NMR spectra and the vapor pressure osmometry (VPO). Although some discrepancies were observed between the association constants obtained from the two methods, the qualitative view was consistent with each other. The analysis of self-aggregation by VPO revealed unique aggregation behavior of DBMs in acetone and toluene, which was not elucidated by the NMR method. Namely, the association constants for infinite association are several times larger than the dimerization constant, suggesting that the aggregation is enhanced by the formation of dimers (a nucleation mechanism). In polar solvents, DBMs aggregate more strongly than in chloroform due to the solvophobic interactions between the macrocyclic framework and the solvents. Moreover, DBMs self-associate in aromatic solvents such as toluene and o-xylene more readily than in chloroform. In particular, the hexameric DBM having a large macrocyclic cavity exhibits extremely large association constants in aromatic solvents. By comparing the aggregation properties of DBMs with the corresponding acyclic oligomers, the effect of the macrocyclic structure on the aggregation propensity was clarified. Finally, it turned out that DBMs tend to aggregate more readily than the corresponding phenylacetylene macrocycles, acetylene-bridged [2(n)]metacyclophanes, owing to the withdrawal of the electron density from the aromatic rings by the butadiyne linkages which facilitates pi-pi stacking interactions.
Ruthenium complexes, e.g., Ru(H)2(CO)(PPh3)3, have been found to catalyze the addition of ortho C–H bonds of aromatic ketones to olefins with a high degree of efficiency and selectivity. 2′-Methylacetophenone reacts with various types of terminal olefins to give 1 : 1 coupling products in good to excellent yields. The C–C bond formation takes place exclusively at the terminal carbon atom of olefins except for styrene which affords a mixture of two regioisomers. Acetylnaphthalenes, cyclic aromatic ketones, and heteroaromatic ketones also react with triethoxyvinylsilane to give 1 : 1 addition products in virtually quantitative yields. From 2′-acetonaphthone or 3-acetylthiophene, in which two different reaction sites are available, only one out of four possible regioisomers is obtained. The importance of the coordination of the oxygen atom of the ketone to ruthenium and the intervention of a cyclometallation intermediate are suggested. A deuterium labeling experiment using acetophenone-d5 and triethoxyvinylsilane shows that an H/D exchange between the aromatic and olefinic positions takes place to some extent, even prior to the formation of the product. This implies that the rate-determining step is not the C–H bond cleavage step, but the product forming step.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.