Soybean [Glycine max (L.) Merr.] cultivars varied in their resistance to different populations of the soybean cyst nematode (SCN), Heterodera glycines, called HG Types. The rhg1 locus on linkage group G was necessary for resistance to all HG types. However, the loci for resistance to H. glycines HG Type 1.3- (race 14) and HG Type 1.2.5- (race 2) of the soybean cyst nematode have varied in their reported locations. The aims were to compare the inheritance of resistance to three nematode HG Types in a population segregating for resistance to SCN and to identify the underlying quantitative trait loci (QTL). 'Hartwig', a soybean cultivar resistant to most SCN HG Types, was crossed with the susceptible cultivar 'Flyer'. A total of 92 F5-derived recombinant inbred lines (RILs; or inbred lines) and 144 molecular markers were used for map development. The rhg1 associated QTL found in earlier studies were confirmed and shown to underlie resistance to all three HG Types in RILs (Satt309; HG Type 0, P = 0.0001 R (2) = 22%; Satt275; HG Type 1.3, P = 0.001, R (2) = 14%) and near isogeneic lines (NILs; or iso-lines; Satt309; HG Type 1.2.5-, P = 0.001 R (2) = 24%). A new QTL underlying resistance to HG Type 1.2.5- was detected on LG D2 (Satt574; P = 0.001, R (2) = 11%) among 14 RILs resistant to the other HG types. The locus was confirmed in a small NIL population consisting of 60 plants of ten genotypes (P = 0.04). This QTL (cqSCN-005) is located in an interval previously associated with resistance to both SDS leaf scorch from 'Pyramid' and 'Ripley' (cqSDS-001) and SCN HG Type 1.3- from Hartwig and Pyramid. The QTL detected will allow marker assisted selection for multigenic resistance to complex nematode populations in combination with sudden death syndrome resistance (SDS) and other agronomic traits.

No abstract

High-rise buildings have been rapidly increasing worldwide due to insufficient land availability in populated areas and their primary role as essential buildings in modern cities and capitals. However, high-rise buildings are very complicated due to the huge number of structural components and elements unlike low-rise buildings, as well as these high-rise buildings demand high structural stability for safety and design requirements. This paper aims to provide brief information about high-rise buildings regarding the basic definition, safety features, structural stability, and design challenges. A brief description of existing structural systems that are available in the literature is presented to articulate a technical issue that has been widely reported, named, adopting an effective structural system for resisting lateral loads resulting from wind and seismic activities. Consequently, a general overview is presented that covers the behavior of various structural systems for different heights of high-rise buildings by implementing a number of nonlinear static procedure analyses (pushover) and nonlinear dynamic procedure analyses (for wind and earthquake loading). Finally, a critical review of the available simplified model and seismic energy base design are also presented. This paper is intended to help in the development and application of construction systems for high-rise buildings in the future.

After perception of specific biotic or abiotic stimuli, such as root colonization by rhizobacteria or selected chemicals, plants can enhance their basal resistance against pathogens. Due to its likely sustainability, this induced resistance will be valuable for disease management in agriculture. This study examined resistance against wheat leaf rust (Puccinia triticina) induced by Pseudomonas protegens CHA0 (CHA0) and β-aminobutyric acid (BABA). Seed dressing with CHA0 reduced the number of sporulating pustules on leaves, and expression of resistance was visible as necrotic or chlorotic leaf flecks. Beneficial effect of CHA0 on wheat seedlings growth was observed in when they were challenged or not with leaf rust. BABA was tested at 10, 15 or 20 mM, and a dose-dependent reduction of leaf rust infections was observed with greatest protection at 20 mM. However, BABA treatment repressed plant growth at 20 mM. Balancing the BABA impact on plant growth and its protective capacity, 15 mM of the compound was selected as suitable to protect wheat seedlings against leaf rust, with the least impact on vegetative host growth. Histological aspects of the pathogen infection process was studied to understand mechanisms of behind the observed resistance. The pre-entry process was not affected by the two resistance inducers, but both treatments reduced fungus penetration and haustorium formation. Timing and amplitude of the resistance reactions were different after bacterial or chemical induction, leading to different levels of resistance. During fungal colonization of host tissues, high deposition of callose and accumulation of H2O2 in both CHA0- and BABA-treated plants indicated important contributions to resistance.

No abstract

The use of concrete reinforced with steel fibers has emerged as an effective material which has the advantages to be used in the most unconventional situations in reinforced concrete structures. These advantages involve reinforcements in structures that intend to resist loads in extreme conditions or change in the type of use, design and or construction errors, degradation of materials (carbonation or corrosion of reinforcement) and also the possible occurrence of accidents such as fires, floods, gusts of wind and earthquakes. In addition, the increasing use of this reinforcement system requires the development of more conclusive studies regarding the characteristics and behaviour of the steel fibers, as well as a critical evaluation of this material and its techniques. This manuscript presents a review on the interaction between steel fibre and the concrete substrate. Initially, a brief description of some fibers materials is made, followed by a summary of some works on adhesion between steel fibres and concrete under static loads. Finally, a summary of the few works on the main contribution of the steel fibers application to increase the strength after the cracking of concrete matrix during loading.

Human activities and climate changes significantly affect our environment, altering hydrologic cycles. Several environmental, social, political, and economical factors contribute to land transformation as well as environmental changes. This study first identified the most critical factors that affect the environment in Al-Anbar city including population growth, urbanization expansion, bare land expansion, and reduction in vegetation cover. The combination of remote sensing data and fuzzy analytic hierarch process (Fuzzy AHP) enabled exploration of land transformations and environmental changes in the study area during 2001 to 2013 in terms of long and short-term changes. Results of land transformation showed that the major changes in water bodies increased radically (94 %) from the long-term change in 2001 to 2013 because of water policies. In addition, the urban class expanded in two shortterm periods (2001-2007 and 2007-2013), representing net changes of 46 and 60 %, respectively. Finally, barren land showed 25 % reduction in the first period because of the huge expansion of water in the lake; a small percentage of growth gain was observed in the second period. Based on the land transformation results, the environmental degradation assessment showed that the study area generally had high level of environmental degradation. The degradation was mostly in the center and the north part of the study area. This study suggested for further studies to include other factors that also responsible for environmental degradation such as water quality and desertification threatening.

No abstract