No abstract

Continuous research on the clean and effective use of coal is still necessary as coal will continue to play a key role in global energy supply for the foreseeable future. Hence, in the current study, the optimisation of in-furnace coal blending for one of Malaysia's opposed-firing utility boilers was numerically executed on the basis of hydrodynamics and combustion characteristics. The predicted FEGT from the numerical model was validated against the actual FEGT from the coal-fired power plant, revealing a difference of less than 10 %. Four (4) coal blended cases were tested, which included both bituminous (bit) and sub-bituminous (sub-bit) coals. The findings demonstrate that due to the difference in density between bit and sub-bit coals, the hydrodynamic performance is predicted to significantly improve when sub-bit coal is injected at the bottom burner as opposed to the upper burner. In terms of kinetics, the higher volatile matter (VM) of sub-bit coal in contrast to bit coal has been postulated to release a substantial amount of volatiles and improve the combustibility of bit coal. Furthermore, enhanced oxygen release from sub-bit coal volatiles can aggravate the gas-solid heterogeneous reaction during bit coal char combustion. As a result of the bottom burner's high temperature, it has been discovered that introducing sub-bit coals into those burners speeds up VM release and char combustion, which increases the rate of combustion. Thus, when combustibility rises, the peak temperature position moves downward, reducing the likelihood of delayed combustion and, consequently, the risk of heat exchanger pendant failure and ash deposition. In a furnace with a relatively long coal residence time, a considerable fraction (>20 %) of high gross calorific value (GCV) sub-bit coal (>5800 kcal/kg) is predicted to produce two peak flame temperatures exceeding 1600°C owing to the likelihood of enhanced char which created delayed combustion. Therefore, a furnace condition with a comparatively shorter coal residence time may aid in the rapid evacuation of residual char from the combustion/burner zone and minimise the potential for delayed combustion. Nonetheless, residual char escape may exacerbate the emission problem by releasing considerable unburned carbon. Overall, the current numerical model has the potential to be a reliable and cost-effective tool for investigating the combustion characteristics of coal blends in a power plant boiler.

No abstract