Highlights Nanocrystalline pseudbrookite thick films  High humidity sensing  Fast response  Short time delay

International audienceThis paper presents a new design of a planar transformer. Over the surface of a flat core, meander-type design was engraved, so that symmetrically adjusted primary and secondary coils, of the same meander-type, can fit into the engraved design. Primary and secondary coils were covered with another flat core consequently forming a compact planar transformer. Windings of primary and secondary coils are printed on both sides of PCB. Conductive stripes of a winding from upper and bottom layer are connected by vias. The transformer was analyzed when the primary and secondary coils were without a core and with a core. High frequency parameters of the transformer were obtained by finite element modeling software and Impedance Analyzer HP4194A in the frequency range from 50 kHz to 1 MHz. The transformer is intended to be used in DC-DC converters (for switching frequency up to several hundred kHz)

This paper describes an innovative design of a wireless, passive LC sensor and its application for monitoring of water content in building materials. The sensor was embedded in test material samples so that the internal water content of the samples could be measured with an antenna by tracking the changes in the sensor’s resonant frequency. Since the dielectric constant of water was much higher compared with that of the test samples, the presence of water in the samples increased the capacitance of the LC circuit, thus decreasing the sensor’s resonant frequency. The sensor is made up of a printed circuit board in one metal layer and water content has been determined for clay brick and autoclaved aerated concrete block, both widely used construction materials. Measurements were conducted at room temperature using a HP-4194A Impedance/Gain-Phase Analyzer instrument.

No abstract

No abstract