Car repair painters usually experience long-term exposure to many different solvents. In Italy, the greater part of car painting shops are "handicraft", i.e. 2-5 workers and small premises. Usually workers do not have specific duties, but everyone takes part in all different operations. Moreover, working time is not standardized but varies according to the workload, working methods tend to be traditional, and compliance to individual protection devices is poor. We have hence assessed, on a sample of 8 italian handicraft car painting shops, the exposure levels to solvents, implementing three classic exposure monitoring methods: environmental sampling with charcoal tubes, personal sampling with diffusive charcoal samplers, and urinary determination of unmetabolised solvents. A simple regression analysis was performed to evaluate relationships between the three series of data. The solvents analysed were toluene, ethylbenzene, 1, 2-dichloropropane, n-butylacetate, n-amylacetate, xylene isomers, ethylacetate, and benzene. Benzene was included due to several factors, among others its presence (1% v/v) in the italian unleaded gasoline. Benzene was found in all shops, at levels around or higher than the 8-h timeweighted average limit (8-h TLV-TWA). Other solvents were found in the different shops at various levels, 10 2 -10 1 times the 8-h TLV-TWA. Air concentrations of toluene, n-butylacetate, xylenes, and benzene were positively correlated with urinary levels of the parent compounds, while a negative correlation was found for ethylbenzene. The health implications of workers' exposure level was briefly discussed.

D2AM is a french CRG beamline installed at the ESRF (European Synchrotron Radiation Facility) in Grenoble, with half of the time dedicated to biological macromolecule crystallography and half to materials science studies (diffraction, wide-angle and small-angle scattering). It is constructed at the front-end BM02 of the ESRF storage ring, using the X-ray beam from a 0.8 T bending magnet. D2AM entered into routine operation at the end of 1994, and is used either for single-wavelength or for multiwavelength anomalous diffraction studies. The beam is monochromated by an Si[111] two-crystal monochromator with a resolution of about 2 x 10(-4). The first crystal is water cooled. The X-ray photon energy covers the range between 6.5 keV (lambda approximately 1.9 A) and 17 keV (lambda approximately 0.7 A), a domain of energy with many K or L absorption edges of heavy atoms of interest for biological macromolecules studies and in materials science. The X-ray beam is focused in the vertical plane by two long curved mirrors and in the horizontal plane by the second crystal of the monochromator which is given an adjustable sagittal curvature. A spot size of 0.3 x 0.1 mm (FWHM) is measured at the sample position. Both mirrors are cut out of a 6"-diameter 1.1 m-long Si single crystal, polished and coated with a 400 A Pt thin film. The rugosity is better than 4 A r.m.s. and the longitudinal slope error is better than 5 x 10(-6) rad r.m.s. The first mirror is water cooled, the second is not. The beam intensity on the sample is about 10(11) photon s(-1) on a 0.3 x 0.3 mm focus area at 100 mA in the storage ring of the ESRF. The harmonic rejection ratio obtained with the two mirrors is better than 10(-5) for lambda/3. The combined optical system, mirror/monochromating-crystals/mirror, used on D2AM constitutes altogether a high-intensity point-focusing fixed-exit monochromator, which has the additional property that the energy resolution is not dependent on the beam divergence in use. Its stability and resolution are perfectly adapted to multiwavelength anomalous diffraction studies. The alignment of the mirrors and the monochromator is fully automated, taking 5 min, with the exception of the adjustment of the sagittal focusing. During multiwavelength diffraction experiments the wavelength is changed by a fast single monochromator rotation. Neither realignment of the mirrors nor readjustment of the beam focusing are necessary. The stability and reproducibility of the selected X-ray photon energy is better than 0.5 eV.

Although smoke-free legislation has transformed the smoking behaviours of some, domestic environments remain an important source of SHS exposure for children. This fact holds true even in the case of parents and other cohabitants who believe they are fully protecting children by smoking only outdoors or at home only when the children are not present. These findings should be included in Italian community-level health promotion interventions for discouraging tobacco use.

This paper reports the results of a field study of occupational pesticide exposure (respiratory and dermal) among a group of Italian agricultural subcontractors. These workers consistently use pesticides during much of the year, thus resulting in a high exposure risk. Ten complete treatments were monitored during spring/summer. Pesticides that were applied included azinphos-methyl, dicamba, dimethoate, terbuthylazine, and alachlor. Several observations were made on worker operative modalities and the use of personal protective equipment (PPE) during work. Total potential and actual exposure ranged from 14 to 5700 microg and from 0.04 to 4600 microg, respectively. Dermal exposure contributed substantially more than inhalation to the total exposure (93.9-100%). Hand contamination ranged from 0.04 to 4600 microg and was the major contributor to dermal exposure. Penetration through specific protective garments was less than 2.4% in all cases, although penetration through general work clothing was as high as 26.8%. The risk evaluation, based on comparison between acceptable daily intake and total absorbed doses, demonstrates that it is presumable to expect possible health effects for workers regularly operating without PPE and improper tractors. Comparisons between exposure levels and operative modalities highlighted that complete PPE and properly equipped tractors contributed to a significant reduction in total exposure to pesticides during agricultural activities. In conclusion, monitored agricultural subcontractors presented very different levels of pesticide exposure due to the high variability of operative modalities and use of PPE. These results indicate the need to critically evaluate the efficacy of training programs required for obtaining a pesticide license in Italy.