In this study, we compare for the first time the nanomechanical properties of lipid bilayer islands on flat and porous surfaces. 1,2-dimyristoyl-sn-glycero-3-phosphatidylcholine (DMPC) and 1,2-dipalmitoyl-sn-glycero-3-phosphatidylcholine (DPPC) bilayers were deposited on flat (silicon and mica) and porous silicon (pSi) substrate surfaces and examined using atomic force spectroscopy and force volume imaging. Force spectroscopy measurements revealed the effects of the underlying substrate and of the lipid phase on the nanomechanical properties of bilayers islands. For mica and silicon, significant differences in breakthrough force between the center and the edges of bilayer islands were observed for both phospolipids. These differences were more pronounced for DMPC than for DPPC, presumably due to melting effects at the edges of DMPC bilayers. In contrast, bilayer islands deposited on pSi yielded similar breakthrough forces in the central region and along the perimeter of the islands, and those values in turn were similar to those measured along the perimeter of bilayer islands deposited on the flat substrates. The study also demonstrates that pSi is suitable solid support for the formation of pore-spanning phospholipid bilayers with potential applications in transmembrane protein studies, drug delivery, and biosensing.
The effect of cholesterol (CHOL) on the material properties of supported lipid bilayers composed of lipid mixtures that mimic the composition of lipid microdomains was studied by force-volume (FV) imaging under near-physiological conditions. These studies were carried out with lipid mixtures of dioleoylphosphatidylcholine, dioleoylphosphatidylserine, and sphingomyelin. FV imaging enabled simultaneous topology and force measurements of sphingomyelin-rich domains (higher domain (HD)) and phospholipid-rich domains (lower domain (LD)), which allowed quantitative measurement of the force needed to puncture the lipid bilayer with or without CHOL. The force required to penetrate the various domains of the bilayer was probed using high- and low-ionic-strength buffers as a function of increasing amounts of CHOL in the bilayer. The progressive addition of CHOL also led to a decreasing height difference between HD and LD. FV imaging further demonstrated a lack of adhesion between the atomic force microscope tip and the HD or LD at loads below the breakthrough force. These results can lead to a better understanding of the role that CHOL plays in the mechanical properties of cellular membranes in modulating membrane rigidity, which has important implications for cellular mechanotransduction.
Expanded cross-linked copolymers of poly(N-isopropylacrylamide) (PNiPAAm) and poly(acrylic acid) (PAAc) of varying monomer ratios were grafted from a crystalline silicon surface. Surface-tethered polymerization was performed at a slightly basic pH, where electrostatic repulsion among acrylic acid monomer units forces the network into an expanded polymer conformation. The influence of this expanded conformation on switchability between a hydrophilic and a hydrophobic state was investigated. Characterization of the copolymer coating was carried out by means of X-ray photoelectron spectroscopy (XPS) ellipsometry, and diffuse reflectance IR. Lower critical solution temperatures (LCSTs) of the copolymer grafts on the silicon surfaces were determined by spectrophotometry. Temperature-induced wettability changes were studied using sessile drop contact angle measurements. The surface topography was investigated by atomic force microscopy (AFM) in Milli-Q water at 25 and 40 degrees C. The reversible attachment of a fluorescently labeled model protein was studied as a function of temperature using a fluorescence microscope and a fluorescence spectrometer. Maximum switching in terms of the contact angle change around the LCST was observed at a ratio of 36:1 PNiPAAm to PAAc. The enhanced control of biointerfaces achieved by these coatings may find applications in biomaterials, biochips, drug delivery, and microfluidics.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.