[1] La Fossa cone is an active stratovolcano located on Vulcano Island in the Aeolian Archipelago (southern Italy). Its activity is characterized by explosive phreatic and phreatomagmatic eruptions producing wet and dry pyroclastic surges, pumice fall deposits, and highly viscous lava flows. Nine 2-D electrical resistivity tomograms (ERTs; electrode spacing 20 m, with a depth of investigation >200 m) were obtained to image the edifice. In addition, we also measured the self-potential, the CO 2 flux from the soil, and the temperature along these profiles at the same locations. These data provide complementary information to interpret the ERT profiles. The ERT profiles allow us to identify the main structural boundaries (and their associated fluid circulations) defining the shallow architecture of the Fossa cone. The hydrothermal system is identified by very low values of the electrical resistivity (<20 W m). Its lateral extension is clearly limited by the crater boundaries, which are relatively resistive (>400 W m). Inside the crater it is possible to follow the plumbing system of the main fumarolic areas. On the flank of the edifice a thick layer of tuff is also marked by very low resistivity values (in the range 1-20 W m) because of its composition in clays and zeolites. The ashes and pyroclastic materials ejected during the nineteenth-century eruptions and partially covering the flank of the volcano correspond to relatively resistive materials (several hundreds to several thousands W m). We carried out laboratory measurements of the electrical resistivity and the streaming potential coupling coefficient of the main materials forming the volcanic edifice. A 2-D simulation of the groundwater flow is performed over the edifice using a commercial finite element code. Input parameters are the topography, the ERT cross section, and the value of the measured streaming current coupling coefficient. From this simulation we computed the self-potential field, and we found good agreement with the measured self-potential data by adjusting the boundary conditions for the flux of water. Inverse modeling shows that self-potential data can be used to determine the pattern of groundwater flow and potentially to assess water budget at the scale of the volcanic edifice. Citation: Revil, A., et al. (2008), Inner structure of La Fossa di Vulcano (Vulcano Island, southern Tyrrhenian Sea, Italy) revealed by high-resolution electric resistivity tomography coupled with self-potential, temperature, and CO 2 diffuse degassing measurements,

Catchment and hillslope hydrology is a major research area in geoscience and the understanding of its underlying processes is still poor. Direct investigation of steep hillslopes via drilling is often infeasible. In this paper, we present the results of non-invasive time-lapse monitoring of a controlled infiltration test at a site in the Italian Central Alps. The hillslope considered is steep (30-35 degrees), covered with grass and a soil layer 1-1.5 m thick above a variably fractured metamorphic bedrock. The key hydrologic question is whether rainfall infiltrates mainly into the underlying fractured bedrock, thus recharging a deeper hydraulic system, or flows in the soil layer as interflow towards the stream channel a few hundred metres downhill. In order to respond to this question, we applied 2200 mm of artificial rain on a 2 m x 2 m slope box over about 18 hours. We estimated the effective infiltration by subtracting the measured runoff (7% of total). Due to the limited irrigation time and the climate conditions, the evapotranspiration was considered as negligible. The soil moisture variation and the underlying bedrock were monitored via a combination of electrical resistivity tomography (ERT), TDR probes and tensiometers. A small-scale 3D cross-hole ERT experiment was performed using 2 m deep boreholes purposely drilled and completed with electrodes in the irrigated plot. A larger scale (35 m long) 2D surface ERT survey was also continuously acquired across the irrigated area. Monitoring continued up to 10 days after the experiment. As a result, we observed a very fast vertical infiltration through the soil cover, also favoured by preferential flow patterns, immediately followed by infiltration into the fractured bedrock. The surface layer showed a fast recovery of initial moisture condition nearly completed in the first 12 hours after the end of irrigation. The lateral transmission of infiltrating water and runoff were negligible as compared to the vertical infiltration. These experiment results confirm that the fractured bedrock has a key role in controlling the fast hydrological dynamics of the small catchment system under study. We concluded that deep water circulation is the key pathway to hillslope processes at this site

On March 15th 2007 a paroxysmal explosion occurred at the Stromboli volcano. This event generated a large amount of products, mostly lithic blocks, some of which impacted the ground as far as down to 200 m a.s.l., about 1.5 km far away from the active vents.Two days after the explosion, a new vapour emission was discovered on the north-eastern flank of the volcanic edifice, at 560 m a.s.l., just above the area called "Nel Cannestra". This new vapour emission was due to a block impact. In order to investigate the block impact area to understand the appearance of the vapour emission, we conducted on May 2008 a multidisciplinary study involving Electrical Resistivity Tomography (ERT), Ground Penetrating Radar (GPR), Self-Potential (SP), CO(2) soil diffuse degassing and soil temperature surveys. This complementary data set revealed the presence of an anomalous conductive body, probably related to a shallow hydrothermal level, at about 10-15 m depth, more or less parallel to the topography. It is the first time that such a hydrothermal fluid flow, with a temperature close to the water boiling point (76 degrees C) has been evidenced at Stromboli at this low elevation on the flank of the edifice. The ERT results suggest a possible link between (1) the main central hydrothermal system of Stromboli, located just above the plumbing system feeding the active vents, with a maximum of subsurface soil temperature close to 90 degrees C and limited by the NeoStromboli summit crater boundary and (2) the investigated area of Nel Cannestra, at similar to 500 m a.s.l., a buried eruptive fissure active 9 ka ago. In parallel, SP and CO(2) soil diffuse degassing measurements suggest in this sector at slightly lower elevation from the block impact crater a magmatic and hydrothermal fluid rising system along the N41 degrees regional fault. A complementary ERT profile, on May 2009, carried out from the NeoStromboli crater boundary down to the block impact crater displayed a flank fluid flow apparently connected to a deeper system. The concept of shallow hydrothermal level have been compared to similar ERT results recently obtained on Mount Etna and La Fossa cone of Vulcano. This information needs to be taken into account in general fluid flow models on volcanoes. In particular, peripheral thermal waters (as those bordering the northeastern coast of Stromboli) could be contaminated by hydrothermal and magmatic fluids coming from regional faults but also from the summit. (C) 2010 Elsevier B.V. All rights reserved

No abstract