Bright, coherent soft X-ray radiation is essential to a variety of applications in fundamental research and life sciences. To date, a high photon flux in this spectral region can only be delivered by synchrotrons, free-electron lasers or high-order harmonic generation sources, which are driven by kHz-class repetition rate lasers with very high peak powers. Here, we establish a novel route toward powerful and easy-to-use SXR sources by presenting a compact experiment in which nonlinear pulse self-compression to the few-cycle regime is combined with phase-matched high-order harmonic generation in a single, helium-filled antiresonant hollow-core fibre. This enables the first 100 kHz-class repetition rate, table-top soft X-ray source that delivers an application-relevant flux of 2.8 × 106 photon s−1 eV−1 around 300 eV. The fibre integration of temporal pulse self-compression (leading to the formation of the necessary strong-field waveforms) and pressure-controlled phase matching will allow compact, high-repetition-rate laser technology, including commercially available systems, to drive simple and cost-effective, coherent high-flux soft X-ray sources.
High-energy, ultrafast, short-wavelength infrared laser sources with high average power are important tools for industrial and scientific applications. Through the coherent combination of four ultrafast thulium-doped rod-type fiber amplifiers, we demonstrate a Tm-doped chirped pulse amplification system with a compressed pulse energy of 1.65 mJ and 167 W of average output power at a repetition rate of 101 kHz. The system delivers 85 fs pulses with a peak power of 15 GW. Additionally, the system presents a high long- and short-term stability. To the best of our knowledge, this is the highest average output power short wavelength IR, mJ-class source to date. This result shows the potential of coherent beam combining techniques in the short wavelength infrared spectral region for the power scalability of these systems.
We investigate the influence of the pump wavelength on the high-power amplification of large-mode area, thulium-doped fibers which are suitable for an ultrashort pulsed operation in the 2 µm wavelength region. By pumping a standard, commercially available photonic crystal fiber in an amplifier configuration at 1692 nm, a slope efficiency of 80 % at an average output power of 60 W could be shown. With the help of simulations we investigate the effect of cross-relaxations on the efficiency and the thermal behavior. We extend our investigations to a rod-type, large-pitch fiber with very large mode area, which is exceptionally suited for high-energy ultrafast operation. Pumping at 1692 nm leads to a slope efficiency of 74 % with a average output power of 67 W, instead of the 38 % slope efficiency obtained when pumping at 793 nm. These results pave the way to highly efficient 2 µm fiber-based CPA systems.
The latest generation of high-energy-class pulsed laser facilities, under construction or planned, such as EuPRAXIA, require reliable pump sources with high power (many kW), brightness (>1 MW/cm2/sr) and electro-optical conversion efficiency (>50%). These new facilities will be operated at high repetition rates (around 100 Hz) and only diode lasers are capable of delivering the necessary performance. Commercial (quasi-continuous wave, QCW) diode laser pulse-pump sources are, however, constructed as low-cost passively cooled stacked arrays that are limited either in brightness, efficiency or repetition rate. Commercial continuous wave diode laser pumps constructed using microchannel coolers (as used in high-value industrial machine tools) can fulfil all requirements, but are typically not preferred, due to their cost and complexity and the challenges of preventing cooler degradation. A custom solution is shown here to fill this gap, using advanced diode lasers in a novel passive side-cooling geometry to realize 100 … 200 Hz pump modules (10%–20% duty cycle) that emit peak power of 6 kW at wavelength = 940 nm. The latest performance of these modules is summarized and compared to literature. We show that a brightness >1 MW/cm2/sr can be efficiently delivered across a wide range of laser pulse conditions with 10% duty cycle (pulse width: 100 µs … 100 ms … cw, repetition rate up to 1 kHz). Furthermore, we describe how these pumps have been used to construct and reliably operate (>109 pulses without degradation) in high-energy-class regenerative and ring amplifiers at the Max-Born-Institut für Nichtlineare Optik und Kurzzeitspektroskopie (MBI). We also show first results on 100 Hz pumping of cryogenically cooled solid-state Yb:YAG slab amplifiers, as anticipated for use in the EuPRAXIA laser, and note that peak temperature is disproportionately increased, indicating that improved cooling and more detailed studies are needed.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.