Episiotomy is an obstetric technique that consists of making an incision in the perineum during vaginal childbirth, to facilitate the baby to pass through. After delivery, the perineal region is sutured with absorbable threads to heal the cut. However, are frequent reports of pain, infections, and dyspareunia after the execution of this technique. In this context, the use of biomaterials becomes relevant as they promote faster and safer tissue repair, making it an attractive alternative for the healing process of episiotomy. Based on the physical-chemical and biological properties of chitosan and Aloe vera, this research developed three different vaginal gels, with the purpose of promoting tissue regeneration and infection prevention post-episiotomy. Chitosan solutions with concentrations of 5% w/v were prepared by dissolving the chitosan powder in 2% v/v aqueous solution of acetic acid. After the extraction and processing of the mucilage, the pulp of the Aloe vera leaf was added to the chitosan gel in the proportions of 1, 2, and 3% v/v. All formulations were neutralized by the slow drip technique of a neutralizing solution of sodium hydroxide (2 M). The compositions were analyzed according to their organoleptic aspect, optical microscopy, spreadability, hydrogen potential, absorption spectroscopy, cytotoxicity, and rheological behavior. Based on the results obtained, it was possible to conclude that gels produced have the potential to be used as vaginal gels.
Early abortion is one of the most common complications during pregnancy. However, the frequent handling of the genital region, more precisely the vagina, which causes discomfort to patients in this abortion process due to the frequency of drug insertion, as four pills are inserted every six hours, has led to the search for alternatives to alleviate the suffering caused by this practice in patients who are already in a shaken emotional state. Hence, this work aimed to develop composites of gelatin and misoprostol, using a conventional single-dose drug delivery system. These composites were prepared by freeze/lyophilization technique, by dissolving the gelatin in distilled water, with a concentration of 2.5% (w/v), and misoprostol was incorporated into the gelatin solution at the therapeutic concentration (800 mcg). They were subsequently molded, frozen and lyophilized. The samples of the composites were then crosslinked with sodium tripolyphosphate (TPP) 1% (v/v) with respect to the gelatin mass for 5 min. The characterization techniques used were: Optical Microscopy (OM), Fourier Transformed Infrared Spectroscopy (FTIR), Thermogravimetry (TG), Swelling, Biodegradation and Cytotoxicity. In OM it was observed that the addition of the drug improved the cylindrical appearance of the compounds, in comparison with the sample that was composed of only gelatin. There was a reduction in the degree of swelling with the addition of the drug and crosslinking. The cytotoxicity test indicated the biocompatibility of the material. Based on the results obtained in these tests, the composites have therapeutic potential for uterine emptying in pregnancy failures, especially in the first trimester.
Chitosan/montmorillonite nanocomposite films were prepared by the solvent evaporation method to immobilize the drug ibuprofen (IBU) and delay its release in a medium that simulates the environment of the gastrointestinal tract. The effects of montmorillonite, at different mass proportions (10, 20, and 50%), on the morphological and physical properties of the films were studied. The samples were characterized by X-ray diffraction (XRD), Infrared Spectroscopy (FTIR), Scanning Electron Microscopy (SEM), degree of swelling, drug encapsulation, and drug release efficiency. According to the XRD it was evidenced that the incorporation of montmorillonite to chitosan led to the formation of nanocomposites of ordered morphology. The infrared spectra confirmed the good interaction between montmorillonite and chitosan by the formation of nanocomposites. This fact, which favored the imprisonment of the IBU, reduced the diffusion coefficient in the studied systems. The micrographs comproved the formation of dense and uniform films. The controlled release profile, especially for the nanocomposite with 10% clay mass, showed a slow drug release rate. The incorporation of montmorillonite at different proportions produced different morphologies, with good encapsulation efficiency and an adequate profile for the controlled release of the drug.
This work aimed to develop chitosan/gelatin scaffolds loaded with ethanolic extract of Jatropha mollissima (EEJM) to evaluate the influence of its content on the properties of these structures. The scaffolds were prepared by freeze-drying, with different EEJM contents (0–10% (w/w)) and crosslinked with genipin (0.5% (w/w)). The EEJM were characterized through High Performance Liquid Chromatography coupled to a Diode Array Detector (HPLC-DAD), and the determination of three secondary metabolites contents was accomplished. The physical, chemical and biological properties of the scaffolds were investigated. From the HPLC-DAD, six main substances were evidenced, and from the quantification of the total concentration, the condensed tannins were the highest (431.68 ± 33.43 mg·g−1). Spectroscopy showed good mixing between the scaffolds’ components. Adding and increasing the EEJM content did not significantly influence the properties of swelling and porosity, but did affect the biodegradation and average pore size. The enzymatic biodegradation test showed a maximum weight loss of 42.89 within 28 days and reinforced the efficiency of genipin in crosslinking chitosan-based materials. The addition of the extract promoted the average pore sizes at a range of 138.44–227.67 µm, which is compatible with those reported for skin regeneration. All of the scaffolds proved to be biocompatible for L929 cells, supporting their potential application as skin tissue engineering materials.
As bentonitas são amplamente investigadas por atuarem como agentes viscosificantes e estabilizantes de fluidos emulsionados. As propriedades dos fluidos de perfuração são extremamente importantes, para o alcance do sucesso da perfuração do poço de petróleo. Todavia, a purificação das argilas se faz necessário para promover uma melhora no comportamento reológico das dispersões. Assim como as argilas bentoníticas naturais, as argilas organofílicas obtidas a partir de argilas bentoníticas sódicas possuem uma gigantesca importância industrial devido ao seu alto grau de inchamento em água, e sais quarternários de amônio. Neste estudo, a influência do tipo de argila é investigada reologicamente em fluidos emulsionados de diferentes proporções mássicas óleo/água (O/W): 50/50, 70/30, 80/20, 90/10 e 95/05 sob a concentração de 6000ppm. As amostras de argilas foram caracterizadas por FRX, DRX E TG/DTA. Todos os fluidos emulsionados de base oleoso foram analisados através de observações morfológicas do tipo macroscópico e reológico. As argilas bentoníticas verde-lodo purificada (hidrofílica) e verde-lodo organofílica (hidrofóbica) foram testadas como agentes viscosificantes e estabilizantes das emulsões. A partir dos resultados, foi possível verificar a composição química das argilas, sendo a argila organofílica a de maior perda ao fogo, a eficiência da intercalação do surfactante na argila verde-lodo organofílica denotada nos difratogramas de raios X, assim como, os eventos de perda de massa, onde a verde-lodo organofílica apresentou uma maior perda. Reologicamente os resultados confirmaram que somente a emulsão contendo argila verde-lodo organofílica de fração mássica 50/50 (O/W) apresentou-se estável fisicamente.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.