Accurate casts can be made with either stock trays or custom trays. An impression made from polyether should be poured only once and within 24 hours after impression making, because of the distortion of the material over time. Silicone impression material has better dimensional stability than polyether. .

No abstract

No abstract

These results might suggest TempBond luting agent as the material of choice for provisional cementation because it allows easier removal of the prosthesis and maintains enough retention to prevent loosening of the restoration. The clinical implication is that the effect of cyclic load on the strength of the cements is different, an important factor in selection of a cement. ImProv had the highest retentive value before and after the two cycles, and TempBond had the lowest. UltraTemp had the highest percentage of retentive value lost. TempBond had no significant loss under loading even though initially it was the weakest.