Interactions of conduit geometry with gas-liquid flows control volcanic activity, implying that the evaluation of volcanic hazards requires quantitative understanding of the inner structure of the volcano. The more established geophysical imaging techniques suffer from inherent ambiguity, may require spatially dense measurements in active areas and may not provide sufficient spatial resolution in the uppermost part of the conduit system. It is thus desirable to develop new imaging techniques allowing a better spatial resolution of a volcano's upper feeding system, with reduced ambiguity and a low level of risk for operators. Muon particles can be utilized to image the internal density distribution of volcanic structures. The principle of muon radiography is essentially the same as X-ray radiography, except for substituting penetrating particles in place of photons. Muons are more attenuated by higher density parts inside the target and thus information about its inner structure are obtained from the differential muon absorption. We report on a muon-imaging experiment that was conducted at Mt Etna in 2010. The target structure was one of the summit craters of the volcano. This experiment was performed using a muon telescope suitably designed to withstand the harsh conditions in the summit zone of a high volcano. We found a marked difference between synthetic and observed attenuation of muons through the target. This discrepancy is likely due to the bias on the observed flux, arising from false muon tracks. They are caused by low-energy particles that, by chance, hit simultaneously the two matrixes of the telescope, leading to detection of a false positive. We separated the useful from the unwanted signal through a first-order model of the background noise. The resulting signal is compared with the corresponding synthetic flux. Eventually, we found regions of higher-and lower-than-expected muon flux, that are possibly related to inner features of the target crater.

[1] During the second half of June, 2008, 50 broadband seismic stations were deployed on Mt Etna volcano in close proximity to the summit, allowing us to observe seismic activity with exceptionally high resolution. 129 long period events (LP) with dominant frequencies ranging between 0.3 and 1.2 Hz, were extracted from this dataset. These events form two families of similar waveforms with different temporal distributions. Event locations are performed by cross-correlating signals for all pairs of stations in a twostep scheme. In the first step, the absolute location of the centre of the clusters was found. In the second step, all events are located using this position. The hypocentres are found at shallow depths (20 to 700 m deep) below the summit craters. The very high location resolution allows us to detect the temporal migration of the events along a dikelike structure and 2 pipe shaped bodies, yielding an unprecedented view of some elements of the shallow plumbing system at Mount Etna. These events do not seem to be a direct indicator of the ongoing lava flow or magma upwelling. Citation:

Volcanic tremor and low frequency events, together with infrasound signals, can represent important precursory phenomena of eruptive activity because of their strict relationship with eruptive mechanisms and with fluid flows through the volcano's feeding system. Important variations of these seismo‐volcanic and infrasound signals, recorded at Mt. Etna volcano, occurred both in the medium‐ and short‐term before the eruption, that took place on 13 May 2008. The most significant changes were observed in the frequency content and location of LP events, as well as in volcanic tremor location, that allowed us to track the magma pathway feeding the 2008 eruptive activity. The infrasound showed three different families of events linked to the activity of the three active vents: North‐East Crater, South‐East crater and the eruptive fissure. The seismic and infrasonic variations reported, corroborated by ground deformations variations, help to develop a quantitative prediction and early‐warning system for effusive and/or explosive eruptions.

[1] One hundred twenty-nine long-period (LP) events, divided into two families of similar events, were recorded by the 50 stations deployed on Mount Etna in the second half of June 2008. During this period lava was flowing from a lateral fracture after a summit Strombolian eruption. In order to understand the mechanisms of these events, we perform moment tensor inversions. Inversions are initially kept unconstrained to estimate the most likely mechanism. Numerical tests show that unconstrained inversion leads to reliable moment tensor solutions because of the close proximity of numerous stations to the source positions. However, single forces cannot be accurately determined as they are very sensitive to uncertainties in the velocity model. Constrained inversions for a crack, a pipe or an explosion then allow us to accurately determine the structural orientations of the source mechanisms. Both numerical tests and LP event inversions emphasise the importance of using stations located as close as possible to the source. Inversions for both families show mechanisms with a strong volumetric component. These events are most likely generated by cracks striking SW-NE for both families and dipping 70°SE (family 1) and 50°NW (family 2). For family 1 events, the crack geometry is nearly orthogonal to the dikelike structure along which events are located, while for family 2 the location gave two pipelike bodies that belong to the same plane as the crack mechanism. The orientations of the cracks are consistent with local tectonics, which shows a SW-NE weakness direction. The LP events appear to be a response to the lava fountain occurring on 10 May 2008 as opposed to the flank lava flow.