China has >400 ports, is home to 7 of 10 biggest ports in the world and its waterway infrastructure construction has been accelerating over the past years. But the increasing number of ports and ships means increasing emissions, and in turn, increasing impact on local and regional air pollution. This paper presents an overview of the broad field of ship emissions in China and their atmospheric impacts, including topics of ship engine emissions and control, ship emission factors and their measurements, developing of ship emission inventories, shipping and port emissions of the main shipping areas in China, and quantitative contribution of shipping emissions to the local and regional air pollution. There have been an increasing number of studies published on all the above aspects, yet, this review identified some critical research gaps, filling of which is necessary for better control of ship emissions, and for lowering their impacts. In particular, there are very few studies on inland ports and river ships, and there are few national scale ship emission inventories available for China. While advanced method to estimate ship emission based on ship AIS activities makes it now possible to develop high spatial- and temporal-resolution emission inventories, the ship emission factors used in Chinese studies have been based mainly on foreign measurements. Further, the contribution of ship emissions to air pollution in coastal cities, the dispersion of pollution plumes emitted by ships, or the chemical evolution process along the transmission path, have so far not been systematically studied in China.

No abstract

No abstract

This study investigated particle and gaseous emission factors from a large cargo vessel for her whole voyage including at berth, manoeuvring and cruising. Quantification of these factors assists in minimising the uncertainty in the current methods of exhaust gas emission factor estimation. Engine performance and emissions from the main marine engine were measured on-board while the ship was manoeuvring and cruising at sea. Emissions of an auxiliary engine working at 55% of maximum continuous rating (MCR) were measured when the ship was at actual harbour stopovers. Gaseous and particle emission factors in this study are presented in g kWh or # kWh, and compared with previous studies. Results showed that the SO emission factor is higher than that of previous studies due to the high sulphur content of the fuel used. The particle number size distributions showed only one mode for different operating conditions of the ship, with a peak at around 40-50 nm, which was dominated by ultrafine particles. Emission factors of CO, HC, PM and PN observed during ship manoeuvring were much higher than that of those recorded at cruising condition. These findings highlight the importance of quantification and monitoring ship emissions in close proximity to port areas, as they can have the highest impact on population exposure.