High temperature intergranular crack tip oxidation under a single 600 s long sustained tensile load at 700 °C was studied for the Ni-base superalloy Allvac 718Plus. High-resolution analytical techniques showed oxidation to take place at and immediately ahead of the tip of an open crack, forming a closed but layered oxide structure about the prior (now oxidized) grain boundary. Near the prior grain boundary the oxide is Ni-rich with a Co-enriched layer furthest away from the metal and a Feenriched region below this. A Cr-rich oxide is present below the outer Ni-rich oxides throughout the crack, also in the direction of crack growth. This is believed to have a hindering effect on oxidation ahead of the crack. Ni 3 (Nb,Al) γ' precipitates close to the grain boundaries were found to oxidize and form regions of near-stoichiometric NiO within the oxide layers. Remaining constituents of γ' (e.g. Al and Nb) were found to be enriched in the surrounding oxidized matrix and also to produce thin oxide layers near the interface between unoxidized metal and the Cr-rich oxide. The formation of the crack tip oxides is discussed with regard to thermodynamics, kinetics and the influence of applied mechanical load.

No abstract

No abstract

Atom probe tomography, APT, is the only microstructural method that can routinely analyse and position individual atoms in a material with a spatial resolution of 0.1-0.5 nm. Recent implementation of pulsed-laser to APT made investigation of less conducting materials, such as oxides, feasible. In this paper a short description of the principle of the techniques is presented. It is followed by examples of recent APT studies of thermally grown oxide scales produced on alumina formers (Pt-modified NiAl diffusion coating and FeCrAl alloy), at the crack tips in a Ni-based alloy and on a Zr-alloy. Additionally results from preliminary studies of ZnO and MgO bulk materials are shown. The obtained information on the atomic scale about the chemistry variations in the scales and at the metal oxide interfaces provides valuable insights into oxidation processes.

The high-temperature sustained load crack growth behaviour of a Ni-base superalloy was investigated using a combination of mechanical testing in controlled atmosphere, fractographical and microanalytical investigations, and finite element modelling. The results show that the local crack front geometry is uneven on two scales: jaggedness on the scale of 100 µm was observed in all specimens, whereas mm-scale waviness could occasionally be observed. The jaggedness can be explained by a percolation-type crack growth along weaker grain boundaries, whereas the large-scale waviness is presumably due to larger regions of the material having specific grain texture with high crack growth resistance. The uneven crack front is shown to potentially have considerable effects on the loading conditions at the crack tip, whereas ligaments of un-cracked material in the crack wake are deemed to have less effect on the crack tip loading due to their low area fraction. The ligaments fail intergranularly in the wake as the crack grows in the present case, as opposed to by creep fracture as previously proposed. Finally, the plastically deformed regions about the crack and crack tip are shown not to exhibit any elevated oxygen levels, implying that the damage in these regions is purely mechanical.