The fluid dynamics within a water tunnel is investigated numerically using a RANS approach with the k-ε turbulence model. The computational model is based on a laser scan of a hydropower tunnel located in Gävunda, Sweden. The tunnel has a typical height of 6.9 m and a width of 7.2 m. While the average cross-sectional shape of the tunnel is smooth the local deviations are significant, where some roughness elements may be in the size of 5 m implying a large variation of the hydraulic radius. The results indicate that the Manning equation can successfully be used to study the localised pressure variations by taking into account the varying hydraulic radius and cross-sectional area of the tunnel. This indicates a dominant effect of the tunnel roughness in connection with the flow, which has the potential to be used in the future evaluation of tunnel durability. ANSYS-CFX was used for the simulations along with ICEM-CFD for building the mesh.
High Reynolds number flow inside a channel of rectangular cross section is examined using Particle Image Velocimetry. One wall of the channel has been replaced with a surface of a roughness representative to that of real hydropower tunnels, i.e. a random terrain with roughness dimensions typically in
Hydropower tunnels are generally subject to a degree of rock falls. Studies explaining this are scarce and the current industrial standards offer little insight. To simulate tunnel conditions, high Reynolds number flow inside a channel with a rectangular cross-section is investigated using particle image velocimetry and pressure measurements. For validation, the flow is modelled using large-eddy simulation (LES) and a Reynolds-averaged Navier-Stokes (RANS) approach with the k − ε turbulence model. One wall of the channel has been replaced with a rough surface captured using laser scanning. The results indicate flow-roughness effects deviating from the standard non-asymmetric channel flow, and hence cannot be properly predicted using spatially averaged relations. These effects manifest as localized bursts of velocity connected to individual roughness elements. The bursts are large enough to affect both temporally and spatially averaged quantities. Both turbulence models show satisfactory agreement for the overall flow behaviour, where LES also provided information for in-depth analysis.
Impinging jets are often used in industry to dry, cool, or heat items. In this work, a two-dimensional Computational Fluid Dynamics model is created to model an impingement jet dryer with a total of 9 pairs of nozzles that dries sheets of metal. Different methods to model the evaporation rate are studied, as well as the influence of recirculating the outlet air. For the studied conditions, the simulations show that the difference in evaporation rate between single- and two-component treatment of moist air is only around 5%, hence indicating that drying can be predicted with a simplified model where vapor is included as a nonreacting scalar. Furthermore, the humidity of the inlet air, as determined from the degree of recirculating outlet air, has a strong effect on the water evaporation rate. Results show that the metal sheet is dry at the exit if 85% of the air is recirculated, while approximately only 60% of the water has evaporated at a recirculation of 92,5%.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.