The EAST research program aims to demonstrate steady-state long-pulse advanced high-performance H-mode operations with ITER-like poloidal configuration and RF-dominated heating schemes. Since last IAEA FEC, EAST has been upgraded with all ITER-relevant auxiliary heating and current drive systems, enabling the investigation of plasma profile control by coupling/integration of various combinations. By means of the 4.6 GHz and 2.45 GHz LHCD systems, H-mode can be obtained and maintained at relatively high density, even up to n e ~ 4.5 × 10 19 m-3 , where a current drive effect is still observed. Significant progress has been achieved on EAST, including: i). Demonstration of a steady-state scenario (fully non-inductive with V loop ~ 0.0V at high β P ~ 1.8 and high performance (H 98,y2 > 1.0) in upper single-null (ε ~ 1.6) configuration with the tungsten divertor; ii) Discovery of a stationary ELM-stable H-mode regime with 4.6 GHz LHCD; iii) achievement of ELM suppression in slowly-rotating H-mode plasma with the application of n = 1 and 2 RMPs.

The recent EAST experimental progress since the last IAEA FEC in 2016 is presented. First demonstration of >100 seconds time scale long-pulse steady-state scenario with a good plasma performance (H98(y2) ~ 1.1) and a good control of impurity and heat exhaust with the tungsten divertor has been successfully achieved on EAST using the pure RF power heating and current drive. The extended operation regimes have been obtained (βP~2.5 & βN~1.9 of using RF&NB and βP~1.9 & βN~1.5). High bootstrap current fraction up to 47% was achieved with q95~6.0-7.0. The interaction effect between the ECH and two LHW systems has been investigated for enhanced current drive and improved confinement quality. ELM suppression using the n= 2 RMPs has been achieved at q95 (≈ 3.2-3.7) with standard type-I ELMy H-mode operational window in EAST. Reduction of the peak heat flux on the divertor was demonstrated using the active radiation feedback control. An increase in the total heating power and improvement of the plasma confinement are expected using a 0-D model prediction for higher bootstrap fraction. Towards long pulse, high bootstrap current fraction operation, a new lower ITER-like tungsten divertor with active watercooling will be installed, together with further increase and improvement of heating and current drive capability.

A critical challenge facing the basic long-pulse high-confinement operation scenario (H mode) for ITER is to control a magnetohydrodynamic (MHD) instability, known as the edge localized mode (ELM), which leads to cyclical high peak heat and particle fluxes at the plasma facing components. A breakthrough is made in the Experimental Advanced Superconducting Tokamak in achieving a new steady-state H mode without the presence of ELMs for a duration exceeding hundreds of energy confinement times, by using a novel technique of continuous real-time injection of a lithium (Li) aerosol into the edge plasma. The steady-state ELM-free H mode is accompanied by a strong edge coherent MHD mode (ECM) at a frequency of 35-40 kHz with a poloidal wavelength of 10.2 cm in the ion diamagnetic drift direction, providing continuous heat and particle exhaust, thus preventing the transient heat deposition on plasma facing components and impurity accumulation in the confined plasma. It is truly remarkable that Li injection appears to promote the growth of the ECM, owing to the increase in Li concentration and hence collisionality at the edge, as predicted by GYRO simulations. This new steady-state ELM-free H-mode regime, enabled by real-time Li injection, may open a new avenue for next-step fusion development.