Films of (1−x)Pb(Zn 1/3 Nb 2/3 )O 3 -xPb(Zr 0.4 Ti 0.6 ) O 3 (x = 0.6, 40PZN-60PZT) were deposited on Pt/TiO 2 / SiO 2 /Si substrate through spin coating. Using a combination of homogeneous precursor solution preparation and two-step pyrolysis process, we were able to obtain the 40PZN-60PZT thin films of perovskite phase virtually without pyrochlore phase precipitation after annealing above 650 • C. But since annealing done at the high temperatures for extended time can cause diffusion of Pt, TiO 2 and Si, and precipitation of nonstoichiometric PbO, we adopted 2-step annealing method to circumvent these problems. The 2-step annealed films show dense microstructure than the 1-step films annealed at higher temperature. Furthermore, the root-mean-square surface roughness of 220 nm thick films which are annealed at 720 • C for 1 min and then annealed at 650 • C for 5 min was found to be 3.9 nm by atomic force microscopy as compared to the 12 nm surface roughness of the film annealed only at 720 • C for 5 min. The electrical properties of 2-step annealed films are virtually same and those of the 1-step annealed films annealed at high temperature. The film 2-step annealed at 720 • C for brief 1 min and with subsequent annealing at 650 • C for 5 min showed a saturated hysteresis loop at an applied voltage of 5 V with remanent polarization (P r ) and coercive voltage (V c ) of 25.3 μC/cm 2 and 0.66 V respectively. The leakage current density was lower than 10 −5 A/cm 2 at an applied voltage of 5 V.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.